Makita BTD132 Instruction Manual page 7
Cordless impact driver
Hide thumbs
Also See for BTD132:
- Instruction manual (57 pages) ,
- Instruction manual (53 pages) ,
- Instruction manual (53 pages)
Table of Contents
Advertisement
This allows a tightening suitable to the work.
Every time the hammering force button
number of blows changes in three steps.
For approximately one minute after releasing the switch
trigger, the hammering force can be changed.
NOTE:
When all lamps on the switch panel go out, the tool
•
is turned off to save the battery power. The
hammer force grade can be checked by pulling the
switch trigger to the extent that the tool does not
operate.
During the operation of switch trigger, the hammer
•
force grade cannot be changed.
Empty signal for remaining
battery capacity
S H
1
009213
Pulling the trigger switch when the remaining battery
capacity become very low makes LED indicator lights
up.
If the tool is used continuously with the LED indicator
lighting up and the battery power is almost used up, the
LED indicator will flicker and the tool itself will stop
Please refer to the following table for the LED indicator
status and the remaining battery capacity.
LED indicator status
OFF
Lighting on
Flickering
The light also flickers three
times a second at the same
time.
009214
NOTE:
When all lamps on the switch panel go out, the tool
•
is turned off to save the battery power. The
remaining battery capacity can be checked by
pulling the switch trigger to the extent that the tool
is pressed, the
1. LED indicator
Remaining battery capacity
Enough
20%
Very low and the tool will stops
does not operate.
All of the lamps on the switch panel go out
•
approximately one minute after releasing the
switch trigger.
If the LED indicator flickers and the tool stops even
•
with a recharged battery cartridge, stop using and
have the tool repaired by a Makita local service
center.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
12 mm
(15/32")
001266
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
For tool without one-touch type
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
1
2
009326
7
9 mm
(3/8")
1. Bit
2. Sleeve
Advertisement
Table of Contents
