Table of Contents
Advertisement
NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT
REMOTE CONTROLLER
This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting
is controlled electronically, the range of control may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can
be controlled from the remote controller.
˚
CH
˚
CH
RESET
AUTO
COOL
DEHUMIDIFY
CIRCULATION
FAN
FAN SPEED
LOW
MED
HI
SLEEPING
STOP (CANCEL)
START (RESERVE)
START/STOP
TIME
TIMER SET
TIMER SELECTOR
ON TIMER
OFF TIMER
AUTO SWING
Signal emitting window/transmission sign
Point this window toward the indoor unit when controlling it.
The transmission sign blinks when a signal is sent.
Display
This indicates the room temperature selected, current time, timer status,
function and intensity of circulation selected.
START/STOP button
Press this button to start operation. Press it again to stop operation.
SLEEP button
Use this button to set the sleep timer.
TEMPERATURE button
Use this button to raise or lower the temperature setting. (Keep pressed,
and the value will change more quickly.)
OFF-TIMER button
ON-TIMER button
TIME button
Use this button to set and check the time and date.
RESET button
FUNCTION selector
Use this button to select the operating mode. Every time you press it,
the mode will change from
to
(CIRCULATION) and to
FAN SPEED selector
This determines the fan speed. Every time you press this button, the intensity
of circulation will change from
(during the
(FAN) mode, from
AUTO SWING button
Controls the angle of the horizontal air deflector.
TIMER control
Use this button to set the timer.
RESERVE button
Time setting reservation.
CANCEL button
Cancel time reservation.
Precautions for Use
Do not put the remote controller in the following places.
Under direct sunlight.
In the vicinity of a heater.
Handle the remote controller carefully. Do not drop it on the floor,
and protect it from water.
Once the outdoor unit stops, it will not restart for about 3 minutes
(unless you turn the power switch off and on or unplug the power
cord and plug it in again).
This is to protect the device and does not indicate a failure.
If you press the FUNCTION selector button during operation, the
device may stop for about 3 minutes for protection.
– 6 –
Select the turn OFF time.
Select the turn ON time.
(AUTO) to
(FAN) cyclically.
(AUTO) to
HI to
(COOL) to
(DEHUMIDIFY)
(HI) to
(MED) to
MED to
LOW).
(LOW)
Hide quick links:
Advertisement
Table of Contents
