Table of Contents
Advertisement
HOW TO INSTALL REFRIGERATOR
3-2. Control the amount of water supplied to the
icemaker.
Caution : • Please unplug the power cord from the wall
outlet and wait for more than three minutes
before disconnecting PWB cover as 310V is
applied in the control panel.
1. Disconnect PWB cover from the upper part of the
refrigerator.
2. Adjust the amount of water supplied by using DIP
switch.
Water Supplying Time Control Option
SWITCH NO
S/W1
S/W2
OFF
OFF
ON
OFF
OFF
ON
ON
ON
OFF
OFF
ON
OFF
OFF
ON
ON
ON
1) The water supplying time is set at five seconds when the
refrigerator is delivered.
2) The amount of water supplied depends on the setting
time and water pressure (city water pressure).
3) If ice cube is too small, increase the water supplying
time. This happens when too small water is supplied into
the ice tray.
4) If ice cube sticks together, decrease the water supplying
time. This happens when too much water is supplied
into the ice tray.
(+) Driver
Water Suppling
S/W3
Time
OFF
6.5 Sec.
OFF
5.5 Sec.
OFF
6 Sec.
OFF
7 Sec.
ON
7.5 Sec.
ON
8 Sec.
ON
9 Sec.
ON
10 Sec.
Caution : When adjusting the amount of water supplied,
adjust step by step. Otherwise the water may
spill over.
Switch ON
ON
Switch OFF
1
2
3
3. When adjustment of control switch for the amount of
water supplied is complete, check the level of water in
the ice tray.
Confirm the amount
- 24 -
of water
Optimum level
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
