Table of Contents
Advertisement
Pin No.
Signal
I/O
28-31
ANI0-ANI3
IN
32
ANI4
IN
33
ANI5
IN
34
ANI6
IN
35
ANI7
IN
36
VDD0
IN
37
AVREF
IN
38
P100
IN
39
P101
IN
40
VSS1
IN
41
P102
IN
42
P103
IN
43
P30
OUT
44-48
P31-P35
OUT
49
P36
OUT
50
P37
IN
51-54 COM0-COM3 OUT
55
BIAS
IN
56
VLC0
IN
57-58
VLC1-VLC2
IN
59
VSS0
IN
60-83
S0-S23
OUT
84-97
P97-P82
OUT
98-99
P81-P80
OUT
100
P25
OUT
Terminal to change cooking input according to the Model.
By using the A/D converter contained in the LSI, DC voltage in accordance with the Model
in operation is applied to set up its cooking constant.
Used for initial balancing of the bridge circuit (absolute humidity sensor). This input is an
analog input terminal from the AH sensor circuit, and connected to the A/D converter built
into the LSI.
AH sensor input.
This input is an analog input terminal from the AH sensor circuit, and connected to the
A/D converter built into the LSI.
Input terminal to judge the model.
The signal out of P117 will be input into ANI6 through G1 line on key matrix. The LSI will
judge the model by this signal.
Signal coming from touch key.
When either G13 line on key matrix is touched, a corresponding signal out of P110 - P117
will be input into ANI7. When no key is touched, the signal is held at "H" level.
Power source voltage : GND(0V).
The power source voltage to drive LSI is input to VDD0 terminal.
A/D converter power source voltage : GND(0V).
The power source voltage to drive the A/D converter. Connected to GND.
Signal similar to ANI7.
When either G12 line on key matrix is touched, a corresponding signal will be input into P100.
Signal similar to ANI7.
When either G11 line on key matrix is touched, a corresponding signal will be input into P101.
Power source voltage : -5.0V.
The power source voltage to the drive LSI is input to VSS1 terminal. Connected to VC.
Signal similar to ANI7.
When either G10 line on key matrix is touched, a corresponding signal will be input into P102.
Signal similar to ANI7.
When either G9 line on key matrix is touched, a corresponding signal will be input into P103.
Terminal not used.
Used for initial balancing of the bridge circuit (absolute humidity sensor).
Signal to sound buzzer (2.0 kHz).
A: Key touch sound.
B: Completion sound.
To input signal which communicates the door open/close information to LSI.
Door close "H" level signal (0V). Door open "L" level signal (-5V).
Terminal not used.
Terminal not used.
Terminal not used.
Terminal not used.
Power source voltage: -5.0V.
The power source voltage to the LSI is input to VSS0 terminal. Connected to VC.
Terminal not used.
Data output terminal to LCD driver IC3.
Terminal not used.
Terminal not used.
23
Description
0.1 sec.
A
2.0 sec.
B
R -330DK
R-330DW
H : GND
L : -5V
H : GND
L : -5V
Hide quick links:
Advertisement
Table of Contents
