Error Diaplay - Canon i320 Simplified Service Manual
Bubble jet printer
Hide thumbs
Also See for i320:
- Quick start manual (56 pages) ,
- Simplified manual (18 pages) ,
- Setup instructions (2 pages)
Table of Contents
Advertisement
3. ERROR DIAPLAY
Errors are displayed by the LEDs, and warnings are displayed by the status monitor.
3-1. Operator Call Error (Orange LED blinking)
LED Display
Blinking 2 times
Paper out
Blinking 3 times
Paper jam
Blinking 6 times
No cartridge installed
Blinking 7 times
Cartridge installed improperly*
(Cartridge EEPROM data is abnormal.)
Blinking 8 times
Waste ink full or platen waste ink full warning
(Approx. 95% of acceptable amount)
3-2. Service Call Error (Orange and green LEDs cyclical blinking)
LED Display
Blinking 2 times
Carriage error
Blinking 6 times
Internal temperature abnormal error
Blinking 7 times
Waste ink full or platen waste ink full error
Blinking 8 times
Abnormal temperature rise
Blinking 9 times
EEPROM error
Blinking 10 times No cartridge installed detection excluding the
case of cartridge replacement (during printing)
3-3. Warning (No LED display)
Content
Black ink low warning 1 (about half amount)
Color ink low warning 1 (about half amount)
Black ink low warning 2 (little amount, "!")
Color ink low warning 2 (little amount, "!")
Black ink low warning 3 (unknown amount, "?")
Color ink low warning 3 (unknown amount, "?")
Head temperature rise
Head temperature over-rise protection
1
*
: Same as when the non-supported cartridge (print head for S300/S330) is installed.
2
*
: Only when the ink remaining amount detection is ON. (Status is not displayed at OFF.)
3
*
: Printer operation at the warning: When the access cover is opened, the carriage does not move to the
cartridge replacement position.
Content
1
Content
Displayed in the status monitor only*
Displayed in the status monitor only*
Displayed in the status monitor only*
Displayed in the status monitor only*
Displayed in the status monitor only*
Displayed in the status monitor only*
Displayed when the access cover is opened, the print
head temperature is high*
lowers, the warning is released.
The carriage stops during printing when the head
temperature is excessive.
6
Corrective Action
Set the paper, and press the RESUME
button to feed the paper.
Remove the jammed paper, and press
the RESUME button.
Install the cartridge, and close the
access cover.
Re-install the cartridge properly, or
power off and on the printer with the
cartridge installed.
Press the RESUME button.
Corrective Action
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Remarks
2
2
2
2
2
2
3
When the head temperature
Advertisement
Table of Contents
