Table of Contents
Advertisement
9-64 Upgrading Your Server
Optical Disk Drive
You may replace the factory-installed optical disk drive with an optional DVD SuperMULTI drive.
IMPORTANT:
by NEC.
Replacement Procedure
Take the following steps to install the optional DVD SuperMULTI drive.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the left side cover and front mask as described earlier in this chapter.
3.
Disconnect the interface and power cables from the factory-installed optical disk drive
from one side of the server.
4.
While pushing the release tabs on both ends of the drive, remove the factory-installed
optical disk drive.
Be sure to use the DVD SuperMULTI drive authorized
Advertisement
Table of Contents
Troubleshooting
