Glass Cooktop; Keypanel And Erc; Maintop Burner Assembly; Testing The Flame Stability - GE Profile J2S968 SERIES Technical Service Manual
Profile dual fuel and profile all gas slide-in ranges
Hide thumbs
Also See for Profile J2S968 SERIES:
- Owner's manual (97 pages) ,
- Installation instructions manual (41 pages) ,
- Instructions (4 pages)
Table of Contents
Advertisement
Testing the Flame Stability
Test 1: Turn the knob from HI to LOW quickly. If
the low flame goes out, increase the flame size
and test again.
Test 2: With the burner on LOW setting, open and
close the oven door quickly. If the flame is
extinguished by the air currents created by the
door movement, increase the flame height and
test again.
Maintop Burner Assembly
WARNING: Shut off gas to the range before
proceeding.
The maintop burner assembly comes out of the
range as one unit.
To remove the maintop burner assembly:
1. Remove the iron burner grates, burner caps,
and burner heads from the glass cooktop.
Burner Grate
2. Remove the control panel assembly (see
Keypanel and ERC).
3. Remove the 5 hex-head screws from the top
inside edge of the control panel frame.
4. Open the door and remove the 5 hex-head
5. Unplug the left connector at the front corner of
6. Remove the 2 hex-head screws at the front
7. Disconnect the gas manifold pipe coupling on
Burner Cap
Burner Head
Glass Maintop
8. Slide the maintop burner assembly forward
– 41 –
screws under the control panel frame.
Remove the control panel frame.
the maintop burner assembly.
Unplug
corners of the maintop burner assembly.
Left Corner
the right side corner of the maintop burner
assembly.
Gas Coupling
and remove. Place it top-side-up on a
protected surface.
Right Corner
Hide quick links:
Advertisement
Table of Contents
