GE Built-In Dishwasher Installation Instructions Manual
Built-in dishwasher
Hide thumbs
Also See for Built-In Dishwasher:
- Installation instructions manual (49 pages) ,
- Owner's manual (32 pages) ,
- Installation instructions (4 pages)
Table of Contents
Advertisement
Quick Links
GE Consumer & Industrial
Appliances
Installation Instructions
Built-In Dishwasher
If you have questions, call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com
In Canada call 1.800.561.3344 or www.GEAppliances.ca
BEFORE YOU BEGIN
STOP
Read these instructions completely and
carefully.
IMPORTANT
– Observe all governing codes and
ordinances.
• Note to Installer – Be sure to leave these instructions for the
consumer's and local inspector's use.
• Note to Consumer – Keep these instructions with your
Owner's Manual for future reference.
• Skill Level – Installation of this dishwasher requires
basic mechanical, electrical and plumbing skills. Proper
installation is the responsibility of the installer. Product
failure due to improper installation is not covered under
the GE Appliance Warranty. See warranty information.
• Completion Time – 1 to 3 Hours. New installations require
more time than replacement installations.
imagination at work
IMPORTANT
be installed to allow for future removal from the enclosure
if service is required.
If you received a damaged dishwasher, you should
immediately contact your dealer or builder.
Optional Accessories – See the Owner's Manual for available
custom panel kits.
FOR YOUR SAFETY
Read and observe all CAUTIONS and WARNINGS
shown throughout these instructions. While performing
installations described in this booklet, gloves and either
safety glasses or goggles should be worn.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
Stainless Steel Tub Models
– The dishwasher MUST
31-30280 04-11 GE
Advertisement
Table of Contents
Related Manuals for GE Built-In Dishwasher
Summary of Contents for GE Built-In Dishwasher
-
Page 1: Installation Instructions
GE Consumer & Industrial Appliances Installation Instructions Built-In Dishwasher If you have questions, call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com In Canada call 1.800.561.3344 or www.GEAppliances.ca BEFORE YOU BEGIN IMPORTANT – The dishwasher MUST STOP be installed to allow for future removal from the enclosure Read these instructions completely and if service is required. -
Page 2: Installation Preparation
Installation Preparation PARTS SUPPLIED WITH Screw Kit Countertop Bracket Kit INSTALLATION KIT: Two #8-18 x 5/8" Phillips special head screws, to ■ #8 Phillips secure dishwasher to underside of countertop or #10 Hex-Head #10 hex screw Special Head Screws #8 Phillips Pan-head Top-Mounting J-Box Screw sides of cabinets. -
Page 3: Prepare Dishwasher Enclosure
Installation Preparation–Enclosure PREPARE DISHWASHER ENCLOSURE • The dishwasher must be installed no more than 10 feet from sink for proper drainage. • The dishwasher must be fully enclosed on the top, sides WARNING To reduce the risk of shock, fire, or injury and back. -
Page 4: Prepare Drain Plumbing
Installation Preparation–Drain METHOD 1–Air Gap with Waste Tee or Disposer PREPARE DRAIN PLUMBING Drain Requirements • Drain hose must not exceed 10 feet in length. • A high drain loop or air gap is required. See below. Drain Method The type of drain installation depends on the following: •... -
Page 5: Prepare Electrical Wiring
Installation Preparation–Electrical Supply PREPARE ELECTRICAL WIRING WARNING WARNING FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker before beginning Alternate installation. Do not use an extension cord or Receptacle adapter plug with this appliance. Location 18" 1-1/2" Dia. Hole (Max.) 18"... - Page 6 Installation Preparation–Hot Water Supply PREPARE HOT WATER SUPPLY CAUTION Hot Water Line • The line may enter from either side, rear or floor within the The hot water supply line pressure must be at least 20 PSI. shaded area shown in Figure F. Lower pressures could cause the water valve to leak and •...
- Page 7 Dishwasher Installation – Type 1 One-hole cable CAUTION Adjust tension by moving spring hook to one of the three holes on the tub leg. Do not remove the wood base until you are ready to install the dishwasher. The dishwasher will tip over INCREASE when the door is opened if the base is removed.
- Page 8 • Remove the four leveling legs on the underside of the wood ordinances. Maximum power cord length is 6 feet. Power Cord base with an adjustable wrench or 15/16" socket. Kit WX09X70910, available for purchase from an authorized • Discard base. GE Appliance Dealer, meets these requirements. White Approx. Ground Black 1/8"...
- Page 9 120" long hose (10 feet) may HOUSE WIRING be purchased from • Position water supply an authorized line and house wiring GE appliance 5" 4" on the floor of the dealer. The 5" Check Valve Hose Clamp enclosure to avoid...
- Page 10 Dishwasher Installation STEP 11 – INSERT DRAIN HOSE STEP 12 – INSTALL COUNTERTOP BRACKETS THROUGH CABINET (Continued) • Position dishwasher in front of cabinet opening. Insert drain • Fasten the 2 brackets to the back of the tub frame in the hose into the hole in cabinet side.
- Page 11 Dishwasher Installation STEP 14 – SLIDE DISHWASHER INTO Special Considerations for Positioning FINAL POSITION Top-Mount Control Models • Push the dishwasher the rest of the way into the cabinet. • Push the sides with your hands. Do not push the dishwasher The controls on these models are designed to be hidden by with your knee, as this will damage the door.
-
Page 12: Dishwasher Installation
Dishwasher Installation STEP 15 – LEVEL DISHWASHER STEP 16 – SECURE DISHWASHER TO COUNTERTOP OR CABINET IMPORTANT – Dishwasher must be level for proper In this step you will need Countertop dish rack operation and wash performance. the 2 Phillips special head Mounting screws set aside in Step 1. -
Page 13: Drain Line Installation
Dishwasher Installation STEP 17 – CONNECT WATER SUPPLY NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FOR PROPER DRAIN OPERATION. Connect water supply line to the 90° elbow. • Slide compression nut, then ferrule over end of water line. DRAIN LINE INSTALLATION •... - Page 14 Dishwasher Installation STEP 19 – CONNECT POWER SUPPLY STEP 20 – PRETEST CHECKLIST Skip this step if dishwasher is equipped with power cord. Review this list after installing your dishwasher to Verify that power is turned off at the source. avoid charges for a service call that is not covered by your •...
- Page 15 Dishwasher Installation STEP 21 – DISHWASHER WET TEST STEP 23 – INSTALL SOUND UPGRADE KIT IF EQUIPPED Turn on power supply (or plug power cord into outlet, ■ if equipped). Skip this step if your model does not have the Sound Upgrade Kit.
- Page 16 STEP 25 – LITERATURE • Be sure to leave complete literature package, Installation Instructions and product samples with the consumer. SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE GE Consumer & Industrial General Electric Company Louisville, Kentucky 40225 GEAppliances.com...