- AU, NZ These operating instructions apply to standard models S 2110 / S 2120 / S 2130 as well as to other S 2000 series vacuum cleaners which are distinguished by names rather than numbers.
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for disposal human health and to the environment.
Page 5
Those features marked * depend on the model, and may vary or not be available on your model. Optional accessories Miele accessories including floorheads, filters and dustbags are available to order from your Miele Vacuum Cleaner Specialist, the Miele Spare Parts Department or on the internet at www.miele-shop.com.
Repairs should only be carried out Any other usage, modification or by a Miele authorised service alteration is at the owner's risk and technician. Repairs and other work by could be dangerous. unqualified persons could be The manufacturer cannot be held liable dangerous.
Page 7
Wait until any freshly cable rewind. For safety reasons this cleaned or shampooed carpets or floor must only be done by the Miele Service coverings are completely dry before Department or a Miele authorised ser- attempting to vacuum.
Page 8
Danger of heavy, hard or have sharp edges. They injury. could cause a blockage and damage Miele vacuum cleaner bags are the appliance. disposable and intended to be used Floor attachments, accessories and only once. Do not attempt to re-use.
Preparing for use Attaching the suction hose a ^ Insert the hose connector into the suction socket until it clicks into position. To remove the suction hose b ^ Press the release buttons at the side of the hose connector, and lift the hose from the socket.
Page 10
Preparing for use Adjusting the telescopic tube One part of this telescopic tube is packed inside the other and can be adjusted to suit your height for comfortable vacuum cleaning. ^ Press the telescopic tube release button to release the tubes and adjust to the required height.
Make sure it clicks into position. e Your Miele vacuum cleaner can be fitted with optional Active Air Clean / Active HEPA filter. This filter can be used instead of the Air Clean filter, which is supplied as standard (see "Maintenance and care - Replacing...
Pull out the mains cable a ^ Pull out the mains cable to the required length (max.cable length approx. 5.5 m). If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. Otherwise there is a danger of overheating.
Adjusting the suction power The suction power can be regulated to suit the type of flooring. Reducing the suction power reduces the amount of effort required to manoeuvre the floorhead. Some models also have symbols on the controls. The symbols indicate the type of use the settings are suitable for.
Parking and storing ParkSystem A parking system has been designed for conveniently parking the vacuum cleaner during pauses. ^ Slot the floorhead into the parking attachment at the back of the vacuum cleaner. Storing ^ Stand the vacuum cleaner upright when it is not being used and during storage.
Customer Contact Centre (see back cover for contact details) or from your The Miele filter system consists of three Miele Vacuum Cleaner Specialist. filters which must be replaced from time to time to ensure that your vacuum cleaner performs efficiently.
Change the dustbag when the colour marker in the dustbag change indicator fills the display, or sooner if it is no longer effective. Miele dustbags are disposable, and designed for single use only. Do not attempt to re-use them as suction would be reduced.
Maintenance and care Replacing the dustbag ^ Press the release button for the dust compartment lid and raise the lid as far as it will go. The dustbag has a closing flap which closes automatically when the dust compartment lid is raised to prevent any dust escaping.
^ Close the filter frame and the dust compartment lid. Replacing the Air Clean filter Replace this filter every time you start a new packet of Miele dustbags. An Air Clean exhaust filter and a dust compartment filter with every packet of Miele dustbag.
Maintenance and care Replacing one type of exhaust filter with another Your Miele vacuum cleaner can be fitted with optional Active Air Clean / Active HEPA filter. This filter can be used instead of the Air Clean filter, which is supplied as standard.
^ Use a suitable tool to remove them from the slots. ^ Fit new thread lifters. Spare parts are available from your Miele Vacuum Cleaner Specialist, from the Miele Spare Parts Department (see back cover for contact details) or the internet at www.miele-shop.com.
Problem solving guide The vacuum cleaner switches off automatically. A temperature limiter switch switches the vacuum cleaner off automatically if it gets too hot. This can occur if, for instance, large articles block the suction tube or when the filter bag is full or contains particles of fine dust.
In the event of a fault that you cannot easily remedy, please contact – your Miele Vacuum Cleaner Specialist – The Miele Customer Contact Centre (see back cover for address). Warranty The appliance is guaranteed for a period of 2 years.
Electrical connection All work should be carried out by a suitably qualified and competent person in strict accordance with national and local safety regulations. The voltage connected load are given on the data plate located underneath the vacuum cleaner. Please ensure that these match the household mains supply.
Page 24
Alteration rights reserved (S 2110 - S 2130) - 1510 M.-Nr. 07 861 720 / 00...