Related Manuals for Kenwood DDX8036BT
Summary of Contents for Kenwood DDX8036BT
- Page 1 MONITOR WITH DVD RECEIVER DDX SERIES DDX8036BT DDX8036BTM INSTALLATION MANUAL © B54-4782-00/00 (MW/M2W/XW)
-
Page 2: Installation Procedure
Accessories Installation Procedure 1. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. 2. Make the proper input and output wire connections for each unit...1 ..6 3. Connect the speaker wires of the wiring harness. - Page 3 not connect the - connector to a rear output After the Installation terminal. After the installation, perform the Initial Setup • After the unit is installed, check whether the brake by referring to the instruction manual. lamps, blinkers, wipers, etc. on the car are working properly.
- Page 4 Connect to the terminal that is grounded when either the telephone rings or during conversation. ⁄ To connect the Kenwood navigation system, consult your navigation manual. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna.
- Page 5 Bluetooth Microphone (Accessory !) (see page 8) Cooling fan FUSE (15A ) Accessory 1 To front left speaker White/Black Reverse sensor wire (Purple/White) REVERSE White Steering remote control input (Light Blue/Yellow) STEERING WHEEL REMOTE CONT REMOTE INPUT To front right speaker Gray/Black Gray Dimmer control wire (Orange/White)
-
Page 6: System Connection
System Connection iPod (commercially available) USB terminal iPod USB device (commercially available) Audio input (iPod/AV Input 3 switchable) Resistance-free stereo type mini plug (3.5φ) Visual input (iPod/AV Input 3 switchable) Resistance-free mini plug (3.5φ) Accessory 4 Accessory 3 Accessory 2 Audio/Visual Output •... -
Page 7: Optional Accessory Connection
(Optional Accessory) Connection cable (Included in the Navigation System) Connection cable ⁄ Navigation units that can be connected to this unit. (Included in the TV tuner) (As of December, 2009): • KNA-G630 • KNA-G630CN For latest information, access the www.kenwood.com/cs/ce/. English... -
Page 8: Installing The Microphone Unit
Installing the Microphone Unit 1. Check the installation position of the microphone (accessory !). 2. Remove oil and other dirt from the installation surface. 3. Install the microphone. 4. Wire the microphone cable up to the unit with it secured at several positions using tape or the like. -
Page 9: Installing The Escutcheon
Installing the Escutcheon For General Motors For Toyota/Scion 1. Cut out accessory 6 to meet the shape of 1. Cut out accessory 6 as illustrated. the opening of the center console. 2. Attach accessory 6 to the unit. Cutting line Cut out to meet the shape of the opening in the vehicle. - Page 10 Installation for Monitor/Player Unit Installation the Monitor/Player Attaching the monitor panel unit Accessory @ Bend the tabs of the mounting sleeve Hold the monitor panel securely so as not to with a screwdriver or similar utensil and drop it accidentally. attach it in place.
-
Page 11: Removing The Unit
Removing Monitor/Player Unit Removing the Hard Rubber Removing the Unit Frame (escutcheon) 1. Remove the hard rubber frame by referring to the removal procedure in the section 1. Engage the catch pins on the removal tool <Removing the Hard Rubber Frame>. 5 and remove the two locks on the lower 2.