Table of Contents
Advertisement
Menu Screen Explanations
WIPE/FADER
PROGRAM AE
W.BALANCE
REC MODE
SOUND
12 BIT
MODE
16 BIT
ZOOM
10X
40X
300X
SNAP MODE
GAIN UP
OFF
AGC
AUTO
DIS
OFF
ON
: Factory-preset
NOTES:
The "
CAMERA" settings are effective when the Power Switch is set to both "
The "
MANUAL" settings are effective only when the Power Switch is set to " ".
Refer to "Fade/Wipe Effects" (
Refer to "Programme AE With Special Effects" (
Refer to "White Balance Adjustment" and "Manual White Balance
Operation" (
pg. 45).
Allows you to set the video recording mode (SP or LP) depending on your
preference (
pg. 13).
Enables video recording of stereo sound on four separate channels, and is
recommended for use when performing audio dubbing. (Equivalent to the
32 kHz mode of previous models)
Enables video recording of stereo sound on two separate channels. (Equiva-
lent to the 48 kHz mode of previous models)
When set to "10X" while using digital zoom, the zoom magnification will
reset to 10X since digital zoom will be disengaged.
Allows you to use the Digital Zoom. By digitally processing and magnifying
images, zooming is possible from 10X (the optical zoom limit), to a maximum
of 40X digital magnification.
Allows you to use the Digital Zoom. By digitally processing and magnifying
images, zooming is possible from 10X (the optical zoom limit), to a maximum
of 300X digital magnification.
Refer to "Basic Shooting (Snapshot)" (
Recording)" (
pg. 42).
Allows you to shoot dark scenes with no picture brightness adjustment.
The overall appearance may be grainy, but the image is bright.
The shutter speed is automatically adjusted (1/25 — 1/200 sec.). Shooting a
subject in low or poor lighting at 1/25 sec. shutter speed provides a brighter
image than in the AGC mode, but the subject's movements are not smooth or
natural. The overall appearance may be grainy. While the shutter speed is
being automatically adjusted, "
To compensate for unstable images caused by camera-shake, particularly at
high magnification.
NOTES:
Accurate stabilisation may not be possible if hand shake is excessive, or
under the following conditions:
•When shooting subjects with vertical or horizontal stripes.
•When shooting dark or dim subjects.
•When shooting subjects with excessive backlighting.
•When shooting scenes with movement in various directions.
•When shooting scenes with low-contrast backgrounds.
Switch off this mode when recording with the camcorder on a tripod.
The "
" indicator blinks or goes out if the Stabiliser cannot be use
pg. 40, 41).
pg. 38, 39).
pg. 26) or "Snapshot (For Video
" is displayed.
" and "
CONTINUED ON NEXT PAGE
47
EN
d.
".
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
