Water Ingress; Disclaimers; Chart Cards And Memory Cards; Emc Installation Guidelines - Raymarine a65 Installation And Operation Instructions Manual
Raymarine new a/c/e series multifunction display
Hide thumbs
Also See for a65:
- Operation instructions manual (390 pages) ,
- Owner's handbook manual (100 pages) ,
- Installation manual (38 pages)
Table of Contents
Advertisement
Water ingress
Water ingress disclaimer
Although the waterproof rating capacity of this product meets the
IPX6 standard, water intrusion and subsequent equipment failure
may occur if the product is subjected to commercial high-pressure
washing. Raymarine will not warrant products subjected to
high-pressure washing.
Disclaimers
This product (including the electronic charts) is intended to be used
only as an aid to navigation. It is designed to facilitate use of official
government charts, not replace them. Only official government
charts and notices to mariners contain all the current information
needed for safe navigation, and the captain is responsible for their
prudent use. It is the user's responsibility to use official government
charts, notices to mariners, caution and proper navigational skill
when operating this or any other Raymarine product. This product
supports electronic charts provided by third party data suppliers
which may be embedded or stored on memory card. Use of such
charts is subject to the supplier's End-User Licence Agreement
included in the documentation for this product or supplied with the
memory card (as applicable).
Raymarine does not warrant that this product is error-free or that it
is compatible with products manufactured by any person or entity
other than Raymarine.
This product uses digital chart data, and electronic information from
the Global Positioning System (GPS) which may contain errors.
Raymarine does not warrant the accuracy of such information and
you are advised that errors in such information may cause the
product to malfunction. Raymarine is not responsible for damages
or injuries caused by your use or inability to use the product, by the
interaction of the product with products manufactured by others, or
by errors in chart data or information utilized by the product and
supplied by third parties.
Chart cards and memory cards
Memory cards are used for archiving data and chart cards provide
additional or upgraded charts.
Compatible cards
The following types of memory or chart card are compatible with
your Raymarine product:
• micro Secure Digital Standard-Capacity (microSDSC)
• micro Secure Digital High-Capacity (microSDHC)
Note: The maximum card capacity supported is 32 GB.
Chart cards
Your product is pre-loaded with electronic charts (worldwide base
map). If you wish to use different chart data, you can insert
compatible chart cards into the unit's card slot.
Use branded chart cards and memory cards
When archiving data, Raymarine recommends the use of quality
branded memory cards. Some brands of memory card may not
work in your unit. Please contact customer support for a list of
recommended cards.
EMC installation guidelines
Raymarine equipment and accessories conform to the appropriate
Electromagnetic Compatibility (EMC) regulations, to minimize
electromagnetic interference between equipment and minimize the
effect such interference could have on the performance of your
system
Correct installation is required to ensure that EMC performance is
not compromised.
For optimum EMC performance we recommend that wherever
possible:
• Raymarine equipment and cables connected to it are:
10
– At least 1 m (3 ft) from any equipment transmitting or cables
carrying radio signals e.g. VHF radios, cables and antennas.
In the case of SSB radios, the distance should be increased
to 7 ft (2 m).
– More than 2 m (7 ft) from the path of a radar beam. A radar
beam can normally be assumed to spread 20 degrees above
and below the radiating element.
• The product is supplied from a separate battery from that used
for engine start. This is important to prevent erratic behavior
and data loss which can occur if the engine start does not have
a separate battery.
• Raymarine specified cables are used.
• Cables are not cut or extended, unless doing so is detailed in
the installation manual.
Note: Where constraints on the installation prevent any of
the above recommendations, always ensure the maximum
possible separation between different items of electrical
equipment, to provide the best conditions for EMC performance
throughout the installation
RF exposure
This transmitter with its antenna is designed to comply with FCC / IC
RF exposure limits for general population / uncontrolled exposure.
The WiFi / Bluetooth antenna is mounted behind the front facia on
the left hand side of the screen. It is recommended to maintain a
safe distance of at least 1 cm from the left hand side of the screen.
FCC
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
FCC Interference Statement (Part 15.105
(b))
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
4. Consult the dealer or an experienced radio / TV technician for
help.
Industry Canada
This device complies with Industry Canada License-exempt RSS
standard(s).
Operation is subject to the following two conditions:
New a Series / New c Series / New e Series
Advertisement
Table of Contents
Troubleshooting
