Table of Contents
Advertisement
3.2.2 Removing the DVD servo board
(See Figs.6 to 8)
Caution:
Solder the short land sections d on the DVD pickup before dis-
connecting the card wire extending from the DVD pickup. If
you do not follow this instruction, the DVD pickup may be dam-
aged.
(1) From the topside of the DVD changer mechanism assem-
bly, solder the short land sections d on the DVD pick up.
(See Fig.6.)
(2) From the bottom side of the DVD changer mechanism as-
sembly, disconnect the card wire from the connectors
(CN201, CN451) on the DVD servo board. (See Fig.7.)
Reference:
When connecting the card wire to the connector CN451,
pass it through the sections e on the DVD traverse
mechanism assembly. (See Fig.7.)
(3) Disconnect the wires from the connectors (CN452, CN453)
on the DVD servo board. (See Fig.7.)
(4) Remove the two screws B attaching the DVD servo board.
(See Fig.7.)
(5) From the reverse side of the DVD servo board, release the
lock of the connector
CN101
and disconnect the card wire. (See Fig.8.)
Caution:
Unsolder the solders from the short land sections d after reas-
sembling. (See Fig.6.)
3.2.3 Removing the switch board
(See Fig.7)
(1) From the bottom side of the DVD changer mechanism as-
sembly, remove the screw C attaching the switch board on
the DVD changer mechanism assembly.
(2) Disconnect the wires from the connectors (CN452, CN453)
on the DVD servo board.
(3) Release the wires from the section f and remove the switch
board.
(4) Release the wires from the sections g and remove the
switch board.
Reference:
When reassembling, pass the wires through the sections (f, g)
as before.
1-26 (No.MB368)
in the direction of the arrow
d
DVD changer mechanism assembly
Fig.6
DVD changer mechanism assembly
e
CN451
B
CN201
B
DVD servo board
DVD traverse mechanism assembly
Fig.7
DVD servo board
Fig.8
DVD pickup
CN453
f
g
Switch board
C
CN452
CN101
Lock
Hide quick links:
Advertisement
Table of Contents
