IBM pSeries 670 Service Manual page 530
Hide thumbs
Also See for pSeries 670:
- Installation manual (128 pages) ,
- Installation manual (198 pages)
Table of Contents
Advertisement
Error Code Description
4068 0EB9 Attention line 8 stuck fault
4068 0EBA Attention line 9 stuck fault
4068 0EBB Attention line 10 stuck fault
4068 0EBC Attention line 11 stuck fault
4068 0EBF Memory error
4068 0EE1 Other bus tests detected fault in service
processor code (invalid MRU to mapping)
4068 0EE2 Other bus tests detected fault in service
processor firmware fault
4068 0EE5 Other bus tests detected firmware error; no
callout available
4068 25E6 SMA 4-port switch adapter fault
4068 273F SMA 2-port switch adapter fault
4069 0001 Memory tests detected clock card assembly
failure
4069 0002 Memory tests detected backplane assembly
failure
4069 0003 Memory tests detected fault in MCM module 0
4069 0004 Memory tests detected fault in MCM module 2
4069 0005 Memory tests detected fault in MCM module 1
4069 0006 Memory tests detected fault in MCM module 3
510
Eserver pSeries 670 Service Guide
Action/
Possible Failing FRU
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
1. Reboot the system in slow mode to the
SMS menus. See "Performing Slow Boot"
on page 345.
2. Examine the service processor error log.
v If a CEC subsystem error (a 4xxx yyyy
error) occurred during the slow boot that
calls out the memory, processors, L3
cache modules, or the primary I/O book,
replace the part indicated by the location
code.
v If a CEC subsystem error (a 4xxx yyyy
error) did not occur during the slow boot,
look for a 4xxx yyyy error immediately
preceding the 406x 0EBF error. Replace
the part indicated by the location code
associated with that error.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
Replace the I/O book (switch adapter) specified
by the location code.
Replace the I/O book (switch adapter) specified
by the location code.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
MCM module 0 and VPD card
Location: U1.18-P1-C1 and U1.18-P1-H2.3
MCM module 2 and VPD card
Location: U1.18-P1-C4 and U1.18-P1-H2.4
MCM module 1 and VPD card
Location: U1.18-P1-C3 and U1.18-P1-H2.5
MCM module 3 and VPD card
Location: U1.18-P1-C2 and U1.18-P1-H2.6
Advertisement
Chapters
Table of Contents
