Replacing The Heat Sink And Fan Assembly - Lenovo ThinkCentre 0267 Hardware Maintenance Manual
Hide thumbs
Also See for ThinkCentre 0267:
- Hardware maintenance manual (350 pages) ,
- Hardware maintenance manual (380 pages) ,
- User manual (144 pages)
Table of Contents
Advertisement
9. Slide the new optical drive into the drive bay until it snaps into position.
Figure 76. Installing a new optical drive
10. Connect the signal cable and the power cable to the rear of the optical drive.
11. To complete the installation or replacement, go to "Completing the parts replacement" on page 160.
Replacing the heat sink and fan assembly
Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre User Guide. To obtain a copy of the ThinkCentre User Guide, go to:
http://www.lenovo.com/ThinkCentreUserGuides
This section provides instructions on how to replace the heat sink and fan assembly.
CAUTION:
The heat sink and fan assembly might be very hot. Turn off the computer and wait three to five
minutes to let the computer cool before removing the computer cover.
To replace the heat sink and fan assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Open the computer cover. See "Opening the computer cover" on page 121.
3. Disconnect the heat sink and fan assembly cable from the microprocessor fan connector on the system
board. See "Locating parts on the system board" on page 77.
Chapter 9
.
Replacing FRUs (Machine Types: 0267, 0385, 1981, 4167, 5025, 5032, 5049, 5070, and 7518)
139
Advertisement
Table of Contents
