Table of Contents
Advertisement
PD-SATA USB/GbE Network Drive
1.5 Before Use
1.5.1
Hard Drive Assembly
Your unit might come with an installed hard drive. Before opening such an enclosure, please read
the warranty and any other notes from your vendor carefully, as this might void your warranty. Be
careful not to damage any cables or components during the installation.
1. Remove the 4 screws on the bottom and then slide the case off the body. You do not need
to remove the screws for the aluminium stand (feet).
2. If the metal shielding is mounted, remove the 4 screws that are holding it in place and then
lift it off the body.
3. Connect the SATA cable and the power line to your hard drive. Install the hard drive and
fasten the 4 screws to hold the drive in place. Align the metal shielding with the body and
fasten the screws, before you slide it back into the casing. Fasten the last 4 screws on the
bottom and then re-connect your power adapter and interface cable.
Note
Always remove the power adapter from the main socket before you open the enclosure!
Page 4
Getting Started
Advertisement
Table of Contents
