GE JB860 Owner's Manual page 26
30" electric free-standing ranges
Hide thumbs
Also See for JB860:
- Owner's manual (64 pages) ,
- Quick start manual (4 pages) ,
- Owner's manual (64 pages)
Table of Contents
Advertisement
Available languages
Available languages
Maintenance (Cont.)
Lift-Off Upper Oven Door
To remove the door:
1. Fully open the door.
2. Lift up on the hinge lock toward the oven frame until
they stop.
stop). The hinge lock will contact the oven frame.
4. On both sides of the door, press down on the release
buttons on each hinge.
6. Pull on hinge arms slightly to relieve pressure on the
locking tabs.
7. Push the hinge locks down onto the hinge.
8. Push the hinges in toward the unit so they are closed.
Oven
frame
Lift-Off Lower Oven Door
Do not lift the door by the handle.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down toward the door frame, to
the unlocked position. A tool, such as a small flat-
blade screwdriver, may be required.
3. Firmly grasp both sides of the door at the top.
4. Close door to the door removal position. The door
should be open approximately 3" with no obstruction
above the door.
the slots.
Slot
Hinge lock
Pull hinge locks down to unlock
26
Door
frame
Release
buttons
Removal position
To replace the door:
1. Pull the hinges down away from the oven frame to
the fully open position.
2. Lift up on the hinge locks toward the oven frame until
they stop.
hinge locks will contact the oven frame.
4. Slide the door back onto the hinges. Make sure the
buttons pop back out.
6. Push the hinge locks down onto the hinge.
7. Close the oven door.
Push in
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Starting on the left side, with the door at the same
angle as the removal position, seat the indentation of
the hinge arm into the bottom edge of the hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for right side.
3. Fully open the door. If the door will not fully open, the
indentation is not seated correctly in the bottom edge
of the slot.
4. Push the hinge locks up against the front frame of the
oven cavity, to the locked position.
Hinge
arm
Hinge
lock
Push hinge locks up to lock
Pull down
Bottom
Hinge arm
edge of
slot
Indentation
49-80764
Hide quick links:
Advertisement
Chapters
Table of Contents
