Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
Parameters
connected—Displays connected routing entries only.
•
•
static—Displays static routing entries only.
•
address address—Specifies the address for which routing information is
displayed.
•
mask—Specifies the network subnet mask of the IP address.
•
prefix-length—Specifies the number of bits that comprise the IP address
prefix. The prefix length must be preceded by a forward slash (/). (Range:
1–32)
•
longer-prefixes—Specifies that the address and mask pair becomes a prefix
and any routes that match that prefix are displayed.
Command Mode
EXEC mode
Example
The following example displays the current routing table state.
Console>
show ip route
console# show ip route
Maximum Parallel Paths: 1 (1 after reset)
IP Forwarding:
Codes: C - connected, S - static, D - DHCP
S
0.0.0.0/0
C
10.5.234.0/24
Console>
show ip route address
Codes: C - connected, S - static, E - OSPF external, * -
candidate default
S 172.1.1.0/24 [5/3] via 10.0.2.1, 17:12:19, Ethernet1
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
CLI\files\IP_Routing.fm
enabled
[1/1] via
10.5.234.254
is directly connected
172.1.1.0 255.255.255.0
IP Routing Protocol-Independent Commands
119:9:27
vlan 1
vlan 1
693
Advertisement
Table of Contents
