hit counter script

Replacing The Fuses; Maintaining The Headlights - Toro 07359 Operator's Manual

Hide thumbs Also See for 07359:
Table of Contents

Advertisement

Replacing the Fuses

There are 7 fuses in the electrical system. They are located
beneath the dash on the driver's side
Alarm/Power Point
Engine
Headlights
Machine fuse
Lift
Rear lift
Horn
1. Fuse block
2. Ground block
(Figure
39).
G017195
Figure 39
3. Pedal assembly

Maintaining the Headlights

Replacing the Bulbs
10 A
CAUTION
10 A
The halogen bulbs become extremely hot when in
10 A
operation. Handling a hot bulb can cause severe
15 A
burns and personal injury.
15 A
Always all enough time to for the bulbs to cool
15 A
before replacing them. Use care whenever handling
the bulb.
30 A
CAUTION
Any surface contamination can damage the
headlight bulb and leading to its failure or explosion
creating a serious safety hazard.
Head light lamps should be handled without
touching the clear quartz, either by using a clean
paper towel or carefully holding the base.
Specification: See your Parts Catalog.
1. Disconnect the battery; refer to
Battery (page
2. Open the hood; refer to
3. Disconnect the electrical connector for the harness
from the connector of the lamp assembly at the back
of the headlight housing
1. Harness-electrical
connector
2. Lamp assembly
4. Rotate the lamp assembly 1/4 turn counterclockwise
and moving it rearward, out of the headlight housing
(Figure
40).
35
Disconnecting the
33).
Raising the hood (page
(Figure
40).
Figure 40
3. Headlight housing
26).

Advertisement

Table of Contents
loading

This manual is also suitable for:

07359tcWorkman mdx-d

Table of Contents