Table of Contents
Advertisement
Table 36 Warning event codes (continued)
Event code
83
84
85
86
87
88
8C
8E
8F
92
DB
F2
Configuration change events
Table 37 Configuration change events
Value
Configuration event
0x41
Drive SCSI changed
0x42
Library SCSI changed
0x43
Drive enable
0x44
Drive disable
126 Troubleshooting
Description
Media attention
Tape drive tape alert; tape drive reported a
warning or critical tape alert.
DHCP request has failed
Autoclean media warning; not enough media
present to support autocleaning.
Drive not supported; the tape drive was disabled
because it cannot be used in this Autoloader.
Drive firmware revision has not changed after a
tape drive firmware upgrade.
Invalid robotics code; does not match with the
loaded Autoloader firmware.
Cleaning tape nearly expired. Only one or two
cleaning operations remain.
2
I
C bus recovery
VPD data recovery.
External drive cooling fan failure (fan motion has
stopped). The subcode indicates which drive sled
fan is affected.
Subcode 00: drive sled #1
Subcode 01: drive sled #2
etc.
Drive sled missing.
Details and Solution
Evaluate media status using L&TT.
Evaluate drive status using L&TT.
Check the network to ensure connection to the
DHCP server.
Check that the network configuration is correct.
If DHCP is enabled, ensure that the DHCP
server is up and running on the device's
network.
Power cycle the device and retry the operation.
Insert a valid cleaning cartridge into the
Autoloader.
Replace the drive with a compatible tape drive.
Verify that the firmware image is correct for the
tape drive.
Retry the operation.
Retry using an alternate firmware upgrade
method.
Install new Autoloader firmware, which will install
a compatible robotics firmware version.
Obtain a new cleaning tape for use when the
current cleaning tape expires.
Contact HP Service if this unexpected condition
occurs.
Power cycle the device and retry the operation.
Verify that the fan for the indicated drive sled is
operational and not obstructed.
NOTE:
The fan only operates when cooling is
required.
Power cycle the device and retry the operation.
Re-seat the tape drive to ensure a good
connection to the device.
Description
Drive SCSI ID has changed
Library SCSI ID changed (*)
Drive was enabled
Drive disabled
- Quick Links:
- Autoloader Options
- Back Panel Overview
Hide quick links:
Advertisement
Table of Contents
