Table of Contents
Advertisement
2.5.2
Operation via Control Terminal
Setting:
DRV-03 [Drive Mode (Run/Stop method)] = 1 (Fx/Rx-1)
DRV-04 [Frequency Mode (Freq. setting method)] = 2 (V1)
1.
Check the LCD display when Power ON. Otherwise, change the setting indicated above.
DRV▶T/V
00
STP
2.
Turn the FX (or RX) terminal ON. Then FWD (or REV) LED will be lit.
DRV▶T/V
00
FWD
3. Set the frequency using V1 (Potentiometer). Output freq (60Hz)., Rotating direction (FWD or REV) and output
current (5A) will be displayed on the LCD.
DRV▶T/V
00
FWD 60.00Hz
4.
Output freq value is decreasing when turning the potentiometer counterclockwise. Inverter output stops at 0.00Hz
and motor is stopped.
DRV▶T/V
00
FWD
5.
Turn FX (or RX) terminal OFF.
DRV▶T/V
00
STP
Morek IT OÜ, Rauna 24, 76506 Saue Harjumaa, Estonia. www.morek.eu Tel. +372 604 1423 Fax +372 604 1447 morek@morek.eu
0.0 A
0.00Hz
0.0 A
0.00Hz
5.0 A
0.0 A
0.00Hz
0.0 A
0.00Hz
35
Chapter 2 - Operation
- Quick Links:
- Basic Wiring
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
