Implementation Information; Configuration Information; Configuration Task List - Dell S4820T Configuration Manual
Hide thumbs
Also See for S4820T:
- Manual (60 pages) ,
- Installation manual (59 pages) ,
- Configuration manual (1178 pages)
Table of Contents
Advertisement
Implementation Information
Dell Networking OS supports both versions of RIP and allows you to configure one version globally and
the other version on interfaces or both versions on the interfaces.
The following table lists the defaults for RIP in Dell Networking OS.
Table 66. RIP Defaults
Feature
Interfaces running RIP
RIP timers
Auto summarization
ECMP paths supported
Configuration Information
By default, RIP is disabled in Dell Networking OS.
To configure RIP, you must use commands in two modes: ROUTER RIP and INTERFACE. Commands
executed in the ROUTER RIP mode configure RIP globally, while commands executed in the INTERFACE
mode configure RIP features on that interface only.
RIP is best suited for small, homogeneous networks. You must configure all devices within the RIP
network to support RIP if they are to participate in the RIP.
Configuration Task List
The following is the configuration task list for RIP.
•
Enabling RIP Globally
•
Configure RIP on Interfaces
•
Controlling RIP Routing Updates
•
Setting Send and Receive Version
•
Generating a Default Route
•
Controlling Route Metrics
•
Summarize Routes
(optional)
•
Controlling Route Metrics
•
Debugging RIP
For a complete listing of all commands related to RIP, refer to the Dell Networking OS Command
Reference Interface Guide.
Routing Information Protocol (RIP)
(mandatory)
(optional)
(optional)
(optional)
(optional)
(optional)
Default
•
Listen to RIPv1 and RIPv2
•
Transmit RIPv1
•
update timer = 30 seconds
•
invalid timer = 180 seconds
•
holddown timer = 180 seconds
•
flush timer = 240 seconds
Enabled
16
787
- Quick Links:
- Accessing the Command Line
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
