Assigning Ip Addresses To An Interface - Dell S4820T Configuration Manual
Hide thumbs
Also See for S4820T:
- Manual (60 pages) ,
- Installation manual (59 pages) ,
- Configuration manual (1178 pages)
Table of Contents
Advertisement
•
Assigning IP Addresses to an Interface
•
Configuring Static Routes
•
Configure Static Routes for the Management Interface
For a complete listing of all commands related to IP addressing, refer to the Dell Networking OS
Command Line Interface Reference Guide.
Assigning IP Addresses to an Interface
Assign primary and secondary IP addresses to physical or logical (for example, [virtual local area network
[VLAN] or port channel) interfaces to enable IP communication between the system and hosts connected
to that interface.
In Dell Networking OS, you can assign one primary address and up to 255 secondary IP addresses to each
interface.
1.
Enter the keyword interface then the type of interface and slot/port information.
CONFIGURATION mode
interface interface
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port
information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
•
For the Management interface on the stack-unit, enter the keyword ManagementEthernet then
the slot/port information. The slot range is from 0 to 1. The port range is 0.
•
For a port channel interface, enter the keywords port-channel then a number.
•
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
2.
Enable the interface.
INTERFACE mode
no shutdown
3.
Configure a primary IP address and mask on the interface.
INTERFACE mode
ip address ip-address mask [secondary]
•
ip-address mask: the IP address must be in dotted decimal format (A.B.C.D). The mask must
be in slash prefix-length format (/24).
•
secondary: add the keyword secondary if the IP address is the interface's backup IP address.
You can configure up to eight secondary IP addresses.
Example the show config Command
To view the configuration, use the show config command in INTERFACE mode or use the show ip
interface command in EXEC privilege mode, as shown in the second example.
Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/1
ip address 10.11.1.1/24
458
(mandatory)
(optional)
(optional)
IPv4 Routing
- Quick Links:
- Accessing the Command Line
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
