Printing From Unix/Linux; Considerations And Limitations; Printing Using Lp Command; Generic "Lp" And "Lptap" Options - Toshiba E-STUDIO2000AC Printing Manual
Multifunction digital systems
Hide thumbs
Also See for E-STUDIO2000AC:
- Software installation manual (164 pages) ,
- Copying manual (132 pages) ,
- Operator's manual (124 pages)
Table of Contents
Advertisement
Printing From UNIX/Linux
0.
This section describes how to print from a UNIX/Linux workstation.
When the User Management setting is enabled, a print job sent from UNIX/Linux workstations is processed as an
invalid job according to the User Authentication Enforcement setting. For more information about the User
Authentication Enforcement setting, refer to the TopAccess Guide.
Before attempting to print from a UNIX/Linux workstation, make sure all the UNIX/Linux Filters are installed in your
workstation. See "Chapter 5: INSTALLING PRINTER DRIVERS FOR UNIX/Linux" in the Software Installation Guide
for details on setting up a UNIX/Linux filter.
For instructions on how to install or set CUPS, refer to the Software Installation Guide.
Considerations and limitations
This equipment acts only as a filter and not as a complete driver. The size and order of the printed pages cannot be
modified.
The UNIX/Linux filters do not support the following engine-supplied features:
- Enlarge/Reduce printing
- Rotate Sort
- N-up printing
- Watermarks
- Cover Sheets
- Sheet Insertion
- Scheduled Print
- Print to Overlay File
- Store to e-Filing
- Use Overlay Image
Linux uses the lptap command to send a file to this equipment.
Since lp is not supported in all versions of Linux, the lptap command should be used instead.
AIX supports printing using the qdaemon. This can be invoked by the user with the commands lp, lpr or qprt. In
order to use the filter, either lp or qprt should be used.
Printing using lp command
Use the lp command (lptap in Linux) to send a file to this equipment for printing. This command specifies various
printer-specific options using the -o option parameter on the command line. The lp command also sets other print
options using various other parameters. Use the "man net_estcolor" command to display the online document that
describes the various options and parameters that can be set to configure printed output.
All the options are sent to this equipment at the start of a print job so, if the print file contains its own commands, they
may override the lp options.
Generic "lp" and "lptap" options
How to print files
Enter the following "Ip" command to print files with the specified printer:
lp -d <queuename> <filename>
Copies
The number of copies of a print job is specified using the "-n <value>" parameter with the "lp" command. The default
value is determined by the "lp" command and it is always 1. The copies are always collated.
Title
The title that is printed on the banner page can be specified using the "-t <title>" parameter with the "lp" command.
The default value is determined by the "lp" command and it is often the name of the print file. If multiple files are
printed using the same "lp" command the default title is set to the name of the first file by the "lp" command.
146 Printing From UNIX/Linux
Hide quick links:
Advertisement
Table of Contents
