hit counter script

Autosensing; Configuring Sd Port Frame Encapsulation; Configuring Receive Data Field Size - Cisco Nexus 5000 Series Configuration Manual

Nx-os san
Hide thumbs Also See for Nexus 5000 Series:
Table of Contents

Advertisement

Configuring Fibre Channel Interfaces
DETAILED STEPS
Command or Action
Step 1
switch# configuration terminal
Step 2
switch(config)# interface fc slot/port
Step 3
switch(config-if)# switchport speed 1000
Step 4
switch(config-if)# no switchport speed

Autosensing

Configuring SD Port Frame Encapsulation

The switchport encap eisl command only applies to SD port interfaces. This command determines the frame
format for all frames transmitted by the interface in SD port mode. If the encapsulation is set to EISL, all
outgoing frames are transmitted in the EISL frame format, for all SPAN sources.
The switchport encap eisl command is disabled by default. If you enable encapsulation, all outgoing frames
are encapsulated, and you will see a new line (Encapsulation is eisl) in the show interface SD_port_interface
command output.

Configuring Receive Data Field Size

You can configure the receive data field size for native Fibre Channel interfaces (but not for virtual Fibre
Channel interfaces). If the default data field size is 2112 bytes, the frame length will be 2148 bytes.
To configure the receive data field size, perform this task:
SUMMARY STEPS
1. switch# configuration terminal
2. switch(config)# interface fc slot/port
3. switch(config-if)# switchport fcrxbufsize 2000
OL-27583-01
Purpose
Enters configuration mode.
Selects the specified interface and enters interface
configuration mode.
Note
Reverts to the factory default (auto) administrative speed of
the interface.
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
Configuring Fibre Channel Interfaces
You cannot configure the port speed of a virtual Fibre
Channel interface.
21

Advertisement

Table of Contents
loading

Table of Contents