Table of Contents
Advertisement
Name of each part
(Front case)
(Top)
(Side)
DRY CONTACT FOR COMMUNICATION ( DRY_CONTACT FOR THERMOSTAT)
1. CN_INDOOR
: Connector for indoor unit
2. CHANGE_OVER_SW : Switch to select External Voltage or Non Voltage for input contact signal
3. CN_OUT(O1,O2)
: Output terminal to show whether the indoor unit is operating (Relay contact)
4. CN_OUT(E3,E4)
: Output terminal to show whether there is an error with the indoor unit (Relay contact)
5. TEMP_SW
: Switch to set the desired temperature of the indoor unit
6. SETTING_SW
: Switch to select whether to use set function of Dry contact
7. CN_Ther/oper
: Input terminal for thermo & operation signal
8. CN_MODE
: Input terminal for Mode signal
9. CN_WIND
: Input terminal for Wind signal
10. DISPLAY_LED
: LED to display the status of Dry contact Module
11. RESET_SW
: Reset switch
(Rear case)
7
2
11
1
(Internal PCB board)
(Side)
Installation manual 5
Name of each part
8
9
6
10
5
4
3
Hide quick links:
Advertisement
Table of Contents
