Installation And Removal Of A Gps Fru Module - Cisco Catalyst IR1800 Rugged Series Hardware Installation Manual
Hide thumbs
Also See for Catalyst IR1800 Rugged Series:
- Installation manual (96 pages) ,
- Connecting (4 pages) ,
- Installation manual (11 pages)
Table of Contents
Advertisement
Installation and Removal of a GPS FRU Module
The IRM-GNSS-ADR hardware is capable of supporting various GNSS constellations. Cisco supports GPS
only on this module with IOS XE release 17.7.1. Please inquire with your sales representative for a roadmap
of support of additional constellations on the IRM-GNSS-ADR module.
Further details on the GPS capabilities can be found in the
Software Configuration
Installation and Removal of a GPS FRU Module
Caution
The module is a FRU, but is not hot swappable. Make sure the device is powered down before replacing.
Procedure
Step 1
Remove the protective cover over the GPS slot by removing the two screws (1) using a Phillips driver, as
shown in the following figure. Retain these two screws for further use.
Figure 27: GPS Slot Cover
1
Step 2
Insert the GPS FRU module into the slot in the device.
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
70
Guide.
GPS Field Replaceable Unit Module
Cisco Catalyst IR1800 Rugged Series Router
Screws
- Quick Links:
- Cisco Ir1821 Router
- Cisco Ir1835 Router
Hide quick links:
Advertisement
Table of Contents
