Table of Contents
Advertisement
Available languages
Available languages
Milk/blended milk drinks too
hot.
Milk froth too thin, loud sucking
noise.
Milk/blended milk drinks too
cold.
No milk/milk froth dispensed.
The water filter does not stay in
position in the water tank.
Water dripped onto the inner
floor of the appliance when the
drip tray was removed.
The brewing unit cannot be
removed.
The appliance cannot be oper-
ated, display messages chang-
ing.
The grinder will not start.
Display shows "Close door"
despite door closed.
Display shows: "Empty trays"
despite empty drip tray - what
to do?
Too little milk in glass or cup.
Too much milk in glass or cup. Use less milk or adjust frothing time.
The milk frother is soiled.
The milk frother is not inserted
in the milk.
The water filter is not mounted
correctly.
Drip tray removed too early.
The brewing unit is not in the
removal position (e.g. frost pro-
tection activated).
The appliance is in demo mode. Hold the k button for at least
The appliance is too hot.
The door is not properly closed. Press the door firmly closed.
The appliance is too hot.
Emptying is not detected when
the appliance is off.
Trouble shooting en
Use more milk or adjust frothing time.
Clean the milk frother in the dish-
washer. ~ "Cleaning the milk
system" on page 45
Use more milk, check whether the milk
frother is inserted in the milk. Slide the
outlet system right down.
Immerse the water filter into water until
no more air bubbles escape; insert the
filter again.
Firmly press the water filter straight
down into the tank connection.
Wait a few seconds after the last drink
was dispensed before removing the
drip tray.
Switch the appliance on again.
5 seconds to deactivate demo mode.
Wait 1 hour so the appliance can cool
down.
Wait 1 hour so the appliance can cool
down.
When the appliance is switched on,
remove and re-insert the drip tray.
49
Advertisement
Chapters
Table of Contents
