A set for the application of an outdoor compressor condensation unit for a non-original evaporation / hvac unit (17 pages)
Summary of Contents for LG LG N1C(W)-L5 Series
Page 1
Installation manual PV Solar MODULE Please read this manual carefully before operating your set and retain it for future reference. N-TYPE MODELS LGXXXN1C(W)-N5 LGXXXN1C(W)-L5 LGXXXN1K-L5 www.lg.com/global/business/solar...
SAFETY The instructions related to the safety indicated in the Do not approach the damaged following are for preventing unexpected danger or or broken module unless you are damage in advance by safely and exactly using the product. an authorized or qualified expert. Failure to comply may result in DANGER serious bodily injury or death.
Page 4
Do not touch the glass surface or Module frame of the solar module after Module Installing structure installation of the module. It may Installing structure (Stralght type) (bent type) result in injury or death. Heavy objects must be kept off of the solar module.
BEFORE & AFTER INSTALLATION Before Installation • Be careful not to damage the cable when using a tool Please carefully read this manual before installation. such as a knife to remove the cable tie that fixes the • Solar module installation and maintenance must be junction box cable.
Diodes properties or physical configurations in the same system. • All LG modules are equipped with factory installed • Match the polarities of cables and terminals when bypass diodes. The factory-installed diodes provide making the connections; failure to do so may result in proper circuit protection for the module from damage to the panel.
PV must be done on the frames of solar modules and arrays output. although the solar modules from LG meet the conditions of • Depending on national directives, additional safety safety class II. The national directives must be respected.
• Select the appropriate orientation to maximize sunlight Excluded Operating Environments exposure. • The solar modules from LG Electronics can not be The module generates maximum output power when it operated in a location where they could come in direct faces the sun directly.
Page 9
• The solar module may be mounted by using the Mounting by using clamps following methods: (*Torque:8~12N∙m) • The module may be fastened to a support by using When installing modules in heavy snow areas, clamps on both the long edge and the short edge of •...
Disclaimer of Liability • By beginning to installation process, the installer has to read and completely understand this Installation Manual. • If installer had any questions regarding this installation manual, the installer would have contacted LG with any questions or concerns.
PRODUCT SPECIFICATIONS N-TYPE Rated electrical characteristic except power rating within -0/+3 percent are within 5 percent of measured. o i t , Cell temp. 25℃, 1.5AM Electrical Properties Mechanical Properties Max. Max. Max. Module Pmax Power Voc at Isc at Vmpp Impp at No.
Page 12
PRODUCT SPECIFICATIONS Electrical Properties(NMOT*) LGXXXN1C(W)-N5 Model Maximum Power (Pmax) 232.4 236.1 239.8 243.5 247.3 251.1 254.9 258.7 262.5 266.4 270.2 273.9 277.2 MPP Voltage (Vmpp) 29.2 29.6 30.0 30.3 30.7 31.1 31.5 31.8 32.2 32.6 33.0 33.3 33.6 MPP Current (Impp) 7.96 7.98 8.00...
Fig 6. Clamping Type Position Load Position Load (mm) Front/Rear(Pa) (mm) Front/Rear(Pa) 0~300 2400/2155 0 ~ 300 5400/2155 800~900 5400/4000 Note) All mechanical installation methods and bolting method in this appendix were not tested by VDE. It is evaluated by LG internal test.
Page 15
Fig 10. Clamping Type Position Load Position Load (mm) Front/Rear(Pa) (mm) Front/Rear(Pa) 0~300 200~400 2400/2155 2155/2155 200~400 0~300 Note) All mechanical installation methods and bolting method in this appendix were not tested by VDE. It is evaluated by LG internal test.
Page 16
Height • Follow the clamp manufacturer’s recommended applied torque to fasten the clamps. • Depth <Edge Clamp> Note) All mechanical installation methods and bolting method in this appendix were not tested by VDE. It is evaluated by LG internal test.
Unloading Flow Guide If you are unloading using heavy equipment such as a crane, please follow the procedure below. [ Step 1 ] [ Step 2 ] [ Step 3 ] [ Step 4 ] Step 1. Place the packaging on a flat surface. Step 2.
Page 18
Seoul 07336, Korea Contact: solar-svc@lge.com http://www.lg-solar.com This document is subject to change without notice. LG, LG logo and Life's Good are trademarks of LG Electronics, Inc. worldwide. Trademarks and intellectual properties of LG Electronics, Inc. are protected by international copyright laws.