Table of Contents
Advertisement
Step
Task
Rotate the levers toward the card to seat the backplane connectors and line card in place. Push on the knurled
5
section of the levers until the thumb tabs pop up and lock the unit in place, as shown in
CAUTION:
the card below it when that card is inserted.
Figure 5-3. Closing the Levers
Figure 5-4. Pressing the Knurled Section of the Lever
Install a blank panel in all slots that do not have a card, and secure it with the screws provided.
6
NOTE:
blank panels are installed in the correct slots.
22
|
RPMs and Line Cards
Installing a card without fully engaging the locking mechanism might damage the EMI seal on
The blank panels for RPMs and line cards are different sizes (RPM blanks are smaller); be sure that
Figure 5-3
and
Figure 5-4.
Advertisement
Table of Contents
