Table of Contents
Advertisement
Management Cable Pinout
Connecting the Console Port
The console port is an asynchronous serial port. If you connect a device to these ports, it must be capable
of asynchronous transmission. Your terminal or terminal emulation mode must be set to VT100 with the
following settings:
• 9600 baud rate (To avoid autobaud input, the default is set to a 9600 BPS.)
• No parity
• 8 data bits
• 1 stop bit
• Window Terminal Emulator option set to NO
• 24 lines X 80 characters
• No flow control
Cable and Adapter Pin Assignments
Use the console port on the RPM of the C7004/C150 to connect to a terminal port, PC serial port, or a
terminal server to configure and monitor your system. An RJ-45 Ethernet cable is required to connect to
the Ethernet port.
The console port is an RJ-45, the pinouts of which are shown in
Figure 6-1. Pinouts for an RJ-45 Connector End of Adaptors
87654321
Table 6-1
displays the RJ-45 console port pin assignments.
Table 6-1. Console Port (RJ-45) Pin Assignments
Pin
Signal
1
NC (unused)
2
DTR
3
TxD
4
GND
Input/Output
-
Output
Output
-
Figure
6-1.
Management Cable Pinout
6
|
25
Advertisement
Table of Contents
