Table of Contents
Advertisement
f Observe the following instructions that are indicated on the caution label at the back of the remote control:
g Do not use old battery with new one.
g Do not use batteries other than the type specified.
g Be sure the batteries are inserted properly.
For other instructions, read the instructions related to batteries that are described in "Read this first!".
Note
f When operating the remote control by directly pointing at the remote control signal receiver of the projector, operate the remote control
within a distance approximately 30 m (98'5") from the remote control signal receiver. The remote control can control at angles of up to ±30°
vertically and horizontally, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.
f The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.
f If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Use
it in a place distant from the light source.
f The power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.
Projector body
Front
1 2 3 4
5
7
8
Rear
9
Chapter 1 Preparation — About your projector
Caution label at the back of the remote control
6
7
9
10
Side
12
8
13
14
8
8
15
16
17
18
ENGLISH - 25
Advertisement
Table of Contents
