Table of Contents
Advertisement
No.
message
068
Position set
Failure to read embroidery frame
sensor signal. (Return)
069
Position Entry
Failure to read embroidery frame
sensor signal. (Entry)
070
Safety sensor
Safety sensor has been tripped.
090
Miss reception
Error has occurred during data transfer (1)Let the machine read pattern data from first.
(via cable) between machine and PC.
091
No send
Data is not put in for over 10 seconds.
103
Data format
Machine unable to determine format of (1)Check format of pattern data.
pattern data.
104
Miss function
Timing to read pattern data doesn't
conform.
105
Dual function
One stitch data has more than 2
functions.
106
No function
Interval between start read time and
time of reception of actual pattern data
108
Improper read
While reading pattern data, there
accrued error in internal processing.
110
Memory full
While reading pattern data, memory
exceeded its capacity.
111
Change over
While reading pattern data, the
frequency of color change (color No.)
exceeded 250 times.
112
Data error
Pattern data of pattern to be
embroidered is damaged.
114
Id over
The number of pattern in memory has
reached maximum of 250.
116
Not found Id
Specified pattern does not exist.
118
Trace data over The stitch number counts over 1024
stitches during preparing Trace data.
Error
(1) Check if position sensor is dirty.
(2) Setup mistake of the machine parameter
(3) Replace position sensor circuit board.
(1)Clear area around safety sensor.
(2)Check material dose not shut out safety
(3) Adjust safety sensor position.
Let the machine read data from first.
(2)By setting reading of pattern data,
Read pattern data again from the first.
(1)Read pattern data again from the first.
(2)
Read pattern data again from the first
Read pattern data again from the first.
(1)Delete unnecessary patterns and read from
(1)
(2)
(1)Read pattern data again from the first.
(2)Read pattern data again if you have
Delete unnecessary patterns and read.
(1)Check setting.
(2)Re-initialize machine system.
Set Embroidery area of pattern data within
2m(X) x 2m(Y).
measure
Turn off power source, then turn on again.
sensor beam.
Check and modify the design data if there is wrong.
the outset.
Modify pattern data and reduce frequency of color
change of one pattern to less than 250 times.
Divide pattern data and reduce frequency of color
change of one pattern to less than 250 times.
a backup data.
(
) ----- Reference instruction book
212
page
E2-7
E5-5,-6
E2-7
E6-3
( 5-5 )
( 5-5 )
(5-6 )
( 10-3 )
( 5-5 )
( 5-5 )
( 5-5 )
( 5-5 )
( 5-B )
(23-1)
( 5-B )
( 5-B )
E4-3
Advertisement
Table of Contents
