Table of Contents
Advertisement
4-6-3 Adjustment of Y carriage drive belt tension
1. Take middle cover and rear cover out.
Rear cover
2. Take out table support cover located front of middle cover.
Table support cover
3. Loosen lock nut of tension adjusting screw.
(you can find this screw under table)
<Spanner> 7mm
Lock nut
Middle cover
4. Loosen screws of Y motor base by half turn.
5. Push belt by push gauge with 500gf.
Belt should hide half of hole for motor fixing screw.
Please adjust tension by tension adjusting screw
< Note >
Push gauge should touch belt with 90 degrees
and be close to table edge.
Hole for motor fixing screw
Tension adjusting screw
9
Advertisement
Table of Contents
