Tuning In A Preset Station; Receiving Fm Stations With Rds; Changing The Rds Information; Searching For Programs By Pty Codes (Pty Search) - JVC UX-A52R Service Manual
Hide thumbs
Also See for UX-A52R:
- Gebruiksaanwijzing (48 pages) ,
- Instructions manual (84 pages) ,
- Instructions manual (42 pages)
Table of Contents
Advertisement
Tuning in a Preset Station
On the remote control ONLY:
1
Press FM/AM repeatedly to select "FM" or "AM
(MW/LW)."
The unit automatically turns on with the last selected
station.
• Each time you press the button, the band alternates
between FM and AM (MW/LW.)
2
Press the number buttons to select a preset number.
Ex. For preset number 5, press 5.
For preset number 15, press +10, then 5.
For preset number 20, press +10, then 10.
For preset number 30, press +10, +10, then 10.
To check the clock time while listening to the
broadcast
On the remote control ONLY:
Press DISPLAY (not on number buttons.)
• Each time you press the button, the source information
and the clock time alternate on the display.
Receiving FM Stations with RDS
RDS (Radio Data System) allows FM stations to send an
additional signal along with their regular program signals.
For example, the stations send their station names, as well
as information about what type of program they broadcast,
such as sports or music, etc.
When tuned to an FM station which provides the RDS
service, the RDS indication lights on the display.
With the unit, you can receive the following types of RDS
signals.
PS (Program Service):
Shows commonly known station names.
PTY (Program Type):
Shows types of broadcast programs.
RT (Radio Text):
Shows text messages the station sends.
Enhanced Other Networks:
Provides the information about the types of the
programs sent by other RDS stations.
More about RDS
• Some FM stations do not provide RDS signals.
• RDS services vary among FM RDS stations. For details on RDS
services in your area, check with local radio stations.
• RDS may not work correctly if the received station is not
transmitting the signals properly or if the signal strength is
weak.
Changing the RDS Information
You can see RDS information on the display while
listening to an FM station.
On the remote control ONLY:
1
Press and hold RDS CONTROL until you finish the
following procedure.
2
Press DISPLAY (on number buttons.)
• Each time you press the button, the display changes
as follows:
PS
(Program Service)
(and Preset number)
3
Release your finger from RDS CONTROL.
If no PS, PTY, or RT signals are sent by a station
"NO PS," "NO PTY," or "NO RT" appears on the display.
If the unit takes time to show the RDS
information received from a station
"WAIT PS," "WAIT PTY," or "WAIT RT" may appear on the
display.
Searching for Programs by PTY Codes (PTY
Search)
One of the advantages of RDS is that you can locate a
particular kind of program by specifying the PTY codes.
• For details on the PTY codes, see "Description of the
PTY codes" on page 19.
To search for a program using the PTY codes
• You need to preset FM RDS stations (if not yet done, see
page 15), and listen to the FM station.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
– 16 –
Continued
PTY
RT
(Program Type)
(Radio Text)
Station frequency
Advertisement
Chapters
Table of Contents
