Page 3
SAFETY SAFETY The instructions related to the safety Please don’t use the module with the indicated in the following are for preven- broken window or the torn back side. ting unexpected danger or damage in There is a danger of electric shock. advance by safely and exactly using the WARNING product.
Page 4
SAFETY If the installing structure has a curved CAUTION surface e.g. arch type as shown in the Please use proper equipment, con- below picture, do not forcefully modify nector, wire and buttress for system con- the module in installation when connec- figuration of the module.
BEFORE & AFTER INSTALLATION BEFORE & AFTER INSTALLATION Before Installation • Do not let anyone approach the solar mo- Please carefully read this manual before dule who has little knowledge of solar mo- installation. dules or on the measures to take when •...
Deposits of foreign material on the frame thods not described in the Installation surface can be cleaned using a wet Instructions please consult LG Electro- sponge or cloth and dried in air or by nics. Failure to do so will void the war- using a clean chamois.
ELECTRICAL INSTALLATION Caution • Modules with a suspected electrical • Avoid all electrical hazards when instal- problem should be returned to LG ling, wiring, operating and maintaining Electronics for inspection and possible a module. repair or replacement as per the •...
ELECTRICAL INSTALLATION Series Connection Parallel Connection The solar modules may be wired in series The solar modules may be combined in • • to produce the desired voltage output. parallel to produce the desired current output. The current of each module connected in •...
The minimum size should be determi- • should be multiplied by a factor of 125 % ned by the applicable codes. LG when determining component voltage Electronics recommends a size not ratings, conductor ampacities, fuse sizes,...
ELECTRICAL INSTALLATION Earth Grounding There is an earth hole in the center of the The solar modules from LG Electronics • • module frame. Using this hole, an earth meet the conditions of Safety Class II. conductor and the solar module frame Therefore grounding is not mandatory.
The fire areas, special care should be taken to resistance of the solar module from install the modules in a manner that LG Electronics is Class C after ANSI/ provides sufficient design strength UL790. while meeting local code requirements.
Page 13
MECHANICAL INSTALLATION Specific information on the solar Mounting by using frame bolts holes • module dimensions and location of Secure the solar module to the struc- • mounting holes is provided in the ture using the factory mounting holes. related data sheet. Four M6 stainless steel bolts, eight flat •...
Page 14
MECHANICAL INSTALLATION LGxxxS1C(W,K)-L4, LGxxxN1C(W,K)-G4 Use four mounting holes on two opposite sides. Clamping Range (250 mm) 150 mm 150 mm Center ± 100mm Clamping Range: Clamping Range: From module Edge From module Edge to 120 mm to 270 mm Center ± 100mm Use four clamps on the short frame and Use four clamps on the short frame.
(WEEE) should be disposed se- maintenance of the module are bey- parately from the municipal waste stream. ond the control of LG Electronics, Old electrical products can contain hazar- • LG Electronics does not assume res-...
TRANSPORTING AND STORAGE TRANSPORTING AND STORAGE Do not loose the banding, when module is • transported by truck, ship and etc. In case of loose banding, module will be shaken, which may cause damage, like glass brea- king. • Do not stack on more than one pallet. The maximum height is two pallets.
Page 17
LG, LG logo and Life‘s Good are trademarks of LG Electronics, Inc. worldwide. Trademarks and intellectual properties of LG Electronics, Inc. are protected by international copyright laws. In case of conflict with other languages of this Installation Instruction the German version shall prevail.
Page 18
More information available at service-solar@lge.de www.lg-solar.com LG Electronics Deutschland GmbH Berliner Straße 93 40880 Ratingen, Germany Tel. +49 (0) 21 02/70 08-0 Fax +49 (0) 21 02/70 08-777...