Advertisement
Wall mount plate
•
Ethernet Port / Power
The MV13 features a 1000BASE-T Ethernet port that supports 802.3af Power-over-Ethernet (PoE).
Pre-Install Preparation
You should complete the following steps before going on-site to perform an installation.
Configure Your Network in Dashboard
The following is a brief overview only of the steps required to add an MV13 to your network. For detailed instructions
about creating, configuring, and managing Meraki Camera networks, refer to the online documentation
(https://documentation.meraki.com/MV).
1. Login to http://dashboard.meraki.com. If this is your first time, create a new account.
2. Find the network you plan to add your cameras or create a new network.
3. Add your cameras to your network. You will need your Meraki order number (found on your invoice)
or the serial number of each camera, which looks like QXXX-XXXX-XXXX and is located on the
bottom of the unit.
4. Verify that your camera is now listed under Cameras > Monitor > Cameras.
Check and Configure Firewall Settings
If a firewall is in place, it must allow outgoing connections on particular ports to particular IP addresses. The most current
list of outbound ports and IP addresses for your specific organization can be found here.
DNS Configuration
Advertisement
