Ospf Host Route Settings - D-Link DGS-3324SRi User Manual
Xstack stackable gigabit layer 3 switch
Hide thumbs
Also See for DGS-3324SRi:
- User manual (392 pages) ,
- Command line interface reference manual (357 pages) ,
- User manual (362 pages)
Table of Contents
Advertisement
Specify the OSPF aggregation settings and click the Apply button to add or change the settings. The new settings will
appear listed in the OSPF Area Aggregation Configuration table. To view the table, click the
Aggregation Entries
link to return to the previous window.
Use the following parameters to configure the following settings for OSPF Area Aggregation:
Parameter
Area ID
Network Number
Network Mask
LSDB Type
Advertisement
Click Apply to implement changes made.
OSPF Host Route Settings
OSPF host routes work in a way analogous to RIP, only this is used to share OSPF information with other OSPF routers.
This is used to work around problems that might prevent OSPF information sharing between routers.
To configure OSPF host routes, click the OSPF Host Route Settings link. To add a new OSPF Route, click the Add
button. Configure the setting in the menu that appears. The Add and Modify menus for OSPF host route setting are nearly
identical. The difference being that if you are changing an existing configuration you will be unable to change the Host
Address. To change an existing configuration, click on the hyperlinked Host Address in the list for the configuration you
want to change and proceed to change the metric or area ID. To eliminate an existing configuration, click the
Delete column for the configuration being removed.
xStack Stackable Gigabit Layer 3 Switch Manual
Figure 6- 129. OSPF Area Aggregation Settings – Add window
Description
Allows the entry the OSPF Area ID for which the routing information will be
aggregated. This Area ID must be previously defined on the Switch.
Sometimes called the Network Address. The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to the OSPF Area
above.
The corresponding network mask for the Network Number specified above.
Specifies the type of address aggregation, which is set at Summary.
Select Enabled or Disabled to determine whether the selected OSPF Area will
advertise it's summary LSDB (Network-Number and Network-Mask).
190
Show All OSPF
in the
Hide quick links:
Advertisement
Table of Contents
