Seq (Standard Mac Acls) - Dell 8 Command Reference Manual
Dell converged enhanced ethernet command reference
Hide thumbs
Also See for 8:
- Owner's manual (346 pages) ,
- Update manual (186 pages) ,
- Getting started manual (172 pages)
Table of Contents
Advertisement
10
seq (standard MAC ACLs)
seq (standard MAC ACLs)
Inserts a rule anywhere in the MAC ACL.
Synopsis
seq value {deny | permit} {any | host MAC _ACL| MAC_ACL} [count]
no seq value
Operands
value
permit or deny
Defaults
By default, no MAC ACLs are configured.
Command
Feature Access Control List Configuration mode
Modes
Description
Use this command to configure rules to match and permit or drop traffic based on source and
destination MAC address and protocol type. You can also enable counters for a specific rule. There
are 255 ACL counters supported per port group. Use the no seq value command to remove a rule
from the MAC ACL.
Usage
There are no usage guidelines for this command.
Guidelines
Example
To create a rule in a MAC standard ACL to permit or to drop traffic from the source MAC address
0022.3333.4444
To delete a filter rule in a MAC standard ACL:
See Also
deny, permit, resequence
154
Specifies the sequence number for the rule. The range of valid values is
0-65535.
Specifies rules to permit or deny traffic.
any
Specifies any source MAC address.
host MAC_ACL
Specifies the source host MAC address for which to set permit or deny
conditions. Use the format HHHH.HHHH.HHHH.
MAC_ACL
Specifies the source host MAC address for which to set permit or deny
conditions. Use the format HHHH.HHHH.HHHH.
count
Enables the counting of the packets matching the rule.
and to enable the counting of packets:
switch(conf-macl-std)#seq 100 deny 0022.3333.4444 count
switch(conf-macl-std)#seq 1000 permit 0022.3333.4444 count
switch(conf-macl-std)#no seq 100
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Advertisement
Table of Contents
