Spanning-Tree Shutdown - Dell 8 Command Reference Manual
Dell converged enhanced ethernet command reference
Hide thumbs
Also See for 8:
- Owner's manual (346 pages) ,
- Update manual (186 pages) ,
- Getting started manual (172 pages)
Table of Contents
Advertisement
spanning-tree shutdown
Enables or disables spanning tree on the interface.
Synopsis
spanning-tree shutdown
no spanning-tree shutdown
Operands
none
Defaults
Spanning tree is not enabled.
Command
Interface configuration mode
Modes
Description
Use this command to disable spanning tree on the interface or VLAN. Use the no spanning-tree
shutdown command to enable spanning tree on the interface or VLAN.
Once all of the interface ports have been configured for a VLAN, you can enable spanning tree
protocol (STP) for all members of the VLAN with a single command. Whichever protocol is currently
selected is used by the VLAN. Only one type of STP can be active at a time.
A physical interface port can be a member of multiple VLANs. For example, a physical port can be a
member of VLAN 1002 and VLAN 55 simultaneously. In addition, VLAN 1002 can have STP enabled
and VLAN 55 can have STP disabled simultaneously.
Usage
There are no usage guidelines for this command.
Guidelines
Examples
To disable spanning tree on a specific interface:
To enable spanning tree on VLAN 1002:
See Also
protocol spanning-tree
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
switch(config)#interface intengigabitethernet 0/1
switch(conf-if-te-0/1)#spanning-tree shutdown
switch(config)#interface vlan 1002
switch(conf-if-vl-1002)#no spanning-tree shutdown
spanning-tree shutdown
11
195
Advertisement
Table of Contents
