Installing A Cmc Module - Dell 8 Owner's Manual
Poweredge modular systems
Hide thumbs
Also See for 8:
- Command reference manual (302 pages) ,
- Update manual (186 pages) ,
- Getting started manual (172 pages)
Table of Contents
Advertisement
3 Reinstall the CMC module and reattach any cables that were
disconnected. See "Installing a CMC Module" on page 273.
On a single CMC system, the SD card activates automatically. For redundant
CMC module systems, initiate a changeover to make the passive module
active using the following steps:
1 Navigate to the Chassis page.
2 Click the Power Management tab.
3 Click the Control sub tab.
4 Select the Reset CMC (warm boot) button.
5 Click Apply.
The CMC will automatically fail over to the redundant module, and that
module now becomes active and displays a solid blue status LED. The SD
card activates automatically.
See the CMC User's Guide for information on configuration and usage of the
FlexAddress feature.
Installing a CMC Module
1 Remove the I/O connector cover. See Figure 4-4.
2 Ensure that the CMC module handle is fully open.
3 Slide the module into the enclosure until the handle contacts the
enclosure.
4 To fully seat the module, close the handle until the release latch snaps into
place.
5 Reconnect the cables that were attached to the module.
Installing Enclosure Components
273
- Quick Links:
- I/O Connectivity
- Troubleshooting Hard Drives
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
