Table of Contents
Advertisement
6. Remove the fan bracket from the server.
7. Remove the fans (see "Replacing a hot-swap fan" on page 37).
To replace the fan bracket, reverse the previous steps.
Power cage assembly
This section contains instructions for removing and replacing the power cage
assembly.
Note:
v Read "Installation guidelines" on page 11.
v Read the safety notices at Appendix B, "Safety information," on page 117.
v Read "Handling static-sensitive devices" on page 13.
Complete the following steps to remove the power cage assembly:
1. Turn off the server and any attached devices.
2. Disconnect external cables and option cables from the back of the server.
3. Remove the server cover (see "Removing the cover" on page 16).
4. Remove the air baffle (see "Removing the air baffle" on page 17).
5. Remove the PCI riser-card assembly (see "Working with adapters" on page 18).
6. Disconnect the power supplies from the power cage assembly.
7. Looking from the front of the server, slide the power cage assembly toward the
left side of the server to disconnect the cage assembly from the system board
connector.
Chapter 4. Field replaceable units
49
Advertisement
Table of Contents
Troubleshooting
