Table of Contents
Advertisement
Installing memory
Your computer has four connectors for installing dual inline memory modules
(DIMMs).
When installing DDR2 type memory modules, the following rules apply:
v Use 1.8 V, 240-pin double data rate 2 synchronous dynamic random access
v Use 256 MB, 512 MB, 1.0 GB, or 2.0 GB memory modules in any combination
To install a memory module:
1. Remove the cover. See "Removing the cover" on page 11.
2. Locate the memory connectors. See "Identifying parts on the system board" on
3. Open the retaining clips.
4. Make sure that the notch 1 on the memory module aligns correctly with the
memory (DDR2 SDRAM).
that provide up to a maximum of 4.0 GB of system memory.
page 15.
connector key 2 on the system board. Push the memory module straight
down into the connector until the retaining clips close.
What to do next:
v To work with another option, go to the appropriate section.
v To complete the installation, go to "Replacing the cover and connecting the
cables" on page 29.
Chapter 1. Installing options
17
Advertisement
Table of Contents
