hit counter script
Download Print this page
GE JKS10 Installation Instructions Manual
GE JKS10 Installation Instructions Manual

GE JKS10 Installation Instructions Manual

27" (68.6 cm), 30" (76.2 cm) models built-in wall oven
Hide thumbs Also See for JKS10:

Advertisement

Ilnstallat!on
nstruct=ons
Built-In Wall Oven
27" (68.6 cm) models
JKS10, JKP30, JKP35, JKP55, JKP70, JKP75,
PK916, PK956, ZEK938,
ZEK958
30" (76.2 cm) models
JTP30, JTP35, JTP55, JTP70, JTP75, PT916,
PT920, PT956, PT960, ZET938,
ZET958
If you have questions, call 1.800.GE.CARES
or visit our website at:
ge.com
Before You Begin
Read these instructions carefully and completely.
• IMPORTANT-save
these
instructions
for local inspector's
use.
• IMPORTANT-observe
all
governing
codes
and ordinances.
• Note to Installer--Be
sure to leave these
instructions
with the consumer.
• Note to Consumer--Keep
these
instructions
for future
reference.
• Proper installation
is the responsibility
of the installer
and product
failure
due
to improper
installation
is NOT covered
under warranty.
• NOTE--This
appliance
must be properly
grounded.
• ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired)
into an approved junction
box. A plug and receptacle
is NOT permitted
on these products.
Parts Included
(Appearance
will vary)
Screws For Installation
(8-18 x .750 flat head
Phillips wood screws)
(68.6 cm)
Metal Bottom
Trim Assembly
(on some models or
can be purchased
separately)
27" (68.6 cm)
Metal Bottom Trim
30" (76.2 cm)
Metal Bottom Trim
Assembly
Materials Needed
Strain Relief Clamp
for 1/2" conduit
Junction
Box
Wire Nuts
36" (91 cm)
of String
Tools Needed
1/8" (3 mm) Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
31-10647-1
03-07 JR

Advertisement

loading

Summary of Contents for GE JKS10

  • Page 1 Built-In Wall Oven 27" (68.6 cm) models JKS10, JKP30, JKP35, JKP55, JKP70, JKP75, Ilnstallat!on PK916, PK956, ZEK938, ZEK958 nstruct=ons 30" (76.2 cm) models JTP30, JTP35, JTP55, JTP70, JTP75, PT916, PT920, PT956, PT960, ZET938, ZET958 If you have questions, call 1.800.GE.CARES or visit our website at: ge.com...
  • Page 2: Important Safety Instructions

    Installation Instructions IMPORTANT SAFETY INSTRUCTIONS Electrical For Your Safety Requirements • Be sure your oven is installed properly cont. a qualified installer or service technician. • Be sure the oven is securely installed in a Rating plate is located on oven side trim, side front frame or lower front frame.
  • Page 3 Installation Instructions Pre-lnstallation Checklist Door removal is not a requirement ALL INSTALLATION INFORMATION installation of the product, but is an added convenience. To remove the door: ON THE FOLLOWING PAGES IS TO BE USED FOR SINGLEAND DOUBLE OVEN INSTALLATION! Open the oven door as far as it will go. Remove packaging materials.
  • Page 4 Jation J for 27" (68.6 For JKSI0, JKP30, JKP70, PK916, ZEK938 models only. Cabinet Width 27" (68.6 cm) 5" (12.7 era) Max. from the Recommended left or right Cutout Location Junction Cabinet _ side --Width Location from Floor 32 1t2" (82.6 cm) "...
  • Page 5 lation I for 27"(68.6cm) For JKP35, JKP55, JKP75, PK956, ZEK958 models only. Cabinet Width 27" (68.6 erR) Recommended Cutout Location from Floor 13 114" (33.7 erR) Junction Box __._ Location Cutout Depth 23 5/8" (60 erR) Min. AHow I" (2.5 era) Cutout Width 25"...
  • Page 6 [ation [ for 27" (68.6 er Cou For JKS10, JKP30, JKPT0, PKPl6, ZEK938 models only. Gas or electric cooktope be installed over this oven. See eooktop installation instructions for cutout s{ze. See _abe_on top of oven for approved cooktop models.
  • Page 7 For JKS10, JKP30, JKP35, JKPS5, JKPT0, JKPT5, PK916, PK956, ZEK938, ZEKg58 models only. SingJe 27" (68.6 cm) Double 27" (68.6 cm) Oven Over Oven Over a Warming Drawer a Warming Drawer Anti-Tip B_ock Against Rear , Anti-Tip Block Against •Wal_ Per...
  • Page 8 27" (68.6 c m) e Ovens only - ;rowave Oven rming For JKS10, JKP30, JKP70, PKgl& ZEK938 modems only. Single 27" (68.6 cm) Oven Singme 27" (68.6 cm) Oven Below an Advantium Between an Advantium Microwave Oven Microwave Oven and a...
  • Page 9 Installation Instructions Cutout for Built-In 30"(76.2 cm)Single Ovens only For JTP30, JTP70, PT916, PT920, ZET938 models only. Cutout 7 3/4" (19.7 cm) Cabinet Width 30" (76.2 cm) Width Max. Junction Box 28 1/2" (72.4 cm), Location Recommended Cutout Location 28 5/8" (72.7 cm). may be Max.
  • Page 10 Installation Instructions IAICutout f or30' 6.2 Built-In Ovens only cm)Double For JTP35, JTP55, JTP75, PT956, PT960, ZET958 models only. Cutout 7 3/4" 30" (76.2 cm) Cabinet Width Width (19.7 cm Junction Box ) Location 28 112" (72.4 cm) Recommended (junction box Min, Cutout Location 28 518"...
  • Page 11 Installation Instructions IA1 Cutout for 30" Single Built-InOvens (76.2cm) only Under Counter For JTP30, JTP70, PT916, PT920, ZET938 models only. Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for cutout size. See label on 240V / 208V top of oven for approved cooktop models.
  • Page 12 Cabinetry Cutout for Single or Double 30"(76.2cm) Built-In Ovens only- Over a Warming Drawer For JTP30, JTP35, JTP55, JTP70, JTP75, PT916, PT920, PT956, PT960, ZET938, ZET958 models only. Double 30" (76.2 cm) Single 30" (76.2 cm) Oven Over a Warming Oven Over a Warming Drawer Drawer...
  • Page 13 30" (76.2 c m) ;rowave Oven rming Drawer For JTP30, JTP70, PTg16, PTg20, ZETg38 models only. SingMe30" (7&2 cm) Oven SingMe30" (76.2 cm) Oven BeMowan Advantium or Between an Advantium or Microwave Oven Microwave Oven and a Warming Drawer Per Advantium Per Advantium Microwave Oven...
  • Page 14: Electrical Connections

    Installation Instructions Electrical Connections Turn off the circuit breaker or remove ATTENTION INSTALLER fuses to the oven branch circuit. All electric wall ovens must be hard wired With the oven supported on a table or (direct wired) into an approved junction platform in front of the cabinet opening, box.
  • Page 15 Installation Instructions New Construction Three-Conductor Branch Four-Conductor Branch Circuit Connection Circuit Connection When connecting to a three-conductor branch circuit, if local codes permit: • When installing in new construction, a. Connect the bare oven ground conductor • When installing in a mobile home, or with the crimped neutral (white) lead to •...
  • Page 16 Installation Instructions lcl Securing the Oven in the Opening Sliding the Oven Into the Drilling the Pilot Holes and Opening Mounting the Oven a. Loop (do not tie) a 36" (91 cm) string around the conduit before the oven is slid NOTE: Before drilling the pilot holes, into place.
  • Page 17 Installation Instructions Installing the Metal Preparing for the Bottom Bottom Trim Trim Installation Place the bottom metal trim centered over a. With oven installed, take the bottom trim the pre-drilled mounting holes. Tape the and center it on the bottom front edge of edges of the trim down to maintain the the cabinet opening.
  • Page 18 Installation Instructions 151 Replacing the Oven Door Open the oven door as far as it NOTE: The oven door is heavy. You will open. may need help lifting the door high enough to slide it into the hinge slots. Push the hinge locks up against the Do not lift the door by the handle.
  • Page 19: Pre-Test Checklist

    Installation Instructions Pre-Test Checklist Check that the bottom trim is installed emove all protective film, if present, and any stickers. properly (see page 17). Check to be sure the mounting screws heck to be sure that all wiring is are installed and flush with the side trim secure and not pinched or in contact with moving parts.
  • Page 20 Notes...