Miele DA 186 Operating And Installation Instructions
Hide thumbs
Also See for DA 186:
- Operating and installation instructions (36 pages) ,
- Operating and installation instructions (28 pages) ,
- Operating and installation instructions (28 pages)
Related Manuals for Miele DA 186
Summary of Contents for Miele DA 186
- Page 1 Operating and installation instructions Cooker hood DA 186 To avoid the risk of accidents GiWOZHr or damage to this appliance it is to read these instructions before it is installed M.-Nr. 06 531 010 and used for the first time.
- Page 2 ......... . 3 .
- Page 3 Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. disposal, and can normally be They are, however, essential for the recycled.
- Page 4 The electrical safety of this This appliance complies with all appliance can only be guaranteed relevant legal safety requirements. when continuity is complete between Inappropriate use can, however, the appliance and an effective earthing lead to personal injury and damage system which complies with local and to property.
- Page 5 The appliance is only completely When using the cooker hood over isolated from the electricity supply a gas hob, ensure that any burners when: in use are always covered by a pan; otherwise flames could be drawn up by – it is switched off at the wall socket the suction of the cooker hood, parts of and the plug withdrawn, which could then be damaged.
- Page 6 Danger of These can be obtained from the Miele suffocation! Dispose of or recycle all Spare Parts department or from packaging safely as soon as possible.
- Page 7 In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
- Page 8 Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useless. Cut off the cable directly behind the appliance to prevent misuse. This should be done by a competent person. The manufacturer cannot be held liable for damage caused by non-compliance with these Warning...
- Page 9 No exchange of The charcoal filters are available to room and outside air can take place. order through your Dealer or the Miele Spare Parts Dept (see back page for When the cooker hood is switched on,...
- Page 11 It is advisable to run the fan for a few (only for recirculation mode) minutes after cooking is finished to neutralise any lingering odours in the air, whether you are using air extraction or recirculation mode. ^ To switch the fan off, close the vapour to which a furniture door front is fitted canopy.
- Page 12 A microfibre "E-Cloth" is available from Before carrying out any cleaning or the Miele UK Spare Parts Department, maintenance work, disconnect the which is suitable for cleaning surfaces cooker hood from the mains supply. such as stainless steel, glass, plastic...
- Page 13 ^ Clean the filters with a soft nylon brush, warm water and a little washing up liquid. place filters upright in the lower basket, and wash on a 65° programme, ensuring that the spray arm is not obstructed. Depending on the cleaning agent used, cleaning the grease filters in a ^ Position the charcoal filters on either dishwasher can cause permanent...
- Page 14 Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that - it is switched off at the wall socket and the plug removed, or - the fuse is withdrawn from the fused spur connection unit, or - the mains fuse is withdrawn,or - the screw-out fuse is removed (in countries where this is applicable).
- Page 15 In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – your Miele Dealer – the Miele Service Department (see back cover for contact details). When contacting the Service Department, please quote the model...
- Page 16 * Furniture panel dimensions C 150 mm, or C 120 mm with reducing collar. The distance betwen the top of the cooker/hob and the bottom of the cooker hood must measure at least 650 mm, unless a greater distance is specified by the manufacturer.
- Page 17 Before installation, it is important to read the information given on the following pages as well as the Warning and Safety instructions at the beginning of this booklet. This is particularly crucial when using the cooker hood at the same ^ Take the filter out and then remove time as a heating appliance that relies on oxygen from the same...
- Page 18 ^ Cut the drilling template for the wall fitting to size, and position against the wall. The top edge of the template indicates the top edge of the appliance. It must be at least H = 1100 mm in order to comply with the safety height required ^ The depth of the unit "T"...
- Page 19 ^ Position the vapour canopy with the furniture door front fitted, and close it. ^ The recirculation grille must be removed when the hood is used in extraction mode. The movement of the vapour canopy can be adjusted if necessary, for instance where a heavy furniture door is fitted.
- Page 20 ^ Remove the vapour canopy. ^ Remove the grease filters. ^ Using the screws at the back of the adjustable brackets, align the cooker ^ Secure the cooker hood to the hood height with that of neighbouring neighbouring units, or fit the side units.
- Page 21 With air extraction: ^ Finally refit the grease filters. ^ If the on-site ventilation system does not have a non-return flap, the non-return flap supplied must be fitted. ^ For extraction connection, secure a flexible ducting or an extraction pipe to the exhaust connection using a hose clip.
- Page 22 additional means of disconnection must All electrical work should be be provided for all poles. undertaken by a suitably qualified For extra safety it is advisable to install and competent person in strict a residual current device (RCD) with a accordance with current national trip current of 30 mA.
- Page 23 – Where ducting is horizontal, it must Important: To avoid the danger of be laid to slope away at at least 1 cm toxic fumes, please observe the per metre. Warning and Safety instructions. This is to ensure that condensate This is especially crucial when using cannot drain back into the cooker the cooker hood at the same time as...
- Page 24 Total connected load ..175 W Fan motor ....135 W Hob lighting ....2 x 20 W Voltage.
- Page 28 M.-Nr. 06 531 010 / 01 Alteration rights reserved / 4605 en - GB...