User Password; Administrator Password; Setting, Changing, And Deleting A Password; Using Security Profile By Device - Lenovo ThinkCentre 8287 Hardware Maintenance Manual
Hide thumbs
Also See for ThinkCentre 8287:
- Hardware maintenance manual (274 pages) ,
- User manual (74 pages) ,
- Manual do utilizador (72 pages)
Table of Contents
Advertisement
User Password
When a User Password is set, the user is prompted to type a valid password each
time the computer is turned on. The computer cannot be used until a valid
password is typed from the keyboard.
Administrator Password
Setting an Administrator Password deters unauthorized persons from changing
configuration settings. If you are responsible for maintaining the settings of several
computers, you might want to set an Administrator Password.
After you set an Administrator Password, a password prompt is displayed each
time you try to access the Setup Utility program.
If both the user and administrator passwords are set, you can type either
password. However, to change any configuration settings, you must use your
administrator password.
Setting, changing, and deleting a password
To set, change, or delete a password, do the following:
Note: A password can be any combination of up to seven characters (A- Z, a-z,
1. Start the Setup Utility program (see "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Security.
3. Select Set Passwords. Read the information displayed on the right side of the
Using Security Profile by Device
Security Profile by Device is used to enable or disable user access to the following
devices:
IDE controller
Diskette Drive Access
Diskette Write Protect
To set Security Profile by Device, do the following:
1. Start the Setup Utility program (see "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Security.
3. Select Security Profile by Device.
4. Select the desired devices and settings and press Enter.
5. Return to the Setup Utility program menu, select Exit, and then Save Settings
54
Hardware Maintenance Manual
and 0-9)
page 53)
screen.
When this feature is set to Disable, all devices connected to the
IDE controller (such as hard disk drives or the CD-ROM drive)
are disabled and will not be displayed in the system
configuration.
When this feature is set to Disable, the diskette drive cannot be
accessed.
When this feature is set to Enable, all diskettes are treated as if
they are write-protected.
page 53)
or Save and exit the Setup Utility.
Advertisement
Table of Contents
