Configuring Basic Network Information (Cli); Enabling The Dhcp Client On The Oob Port; Enabling The Dhcp Client On The Default Vlan - Dell M6220 User Configuration Manual
Hide thumbs
Also See for M6220:
- Getting started manual (182 pages) ,
- Configuration manual (126 pages) ,
- Cli reference manual (1152 pages)
Table of Contents
Advertisement
Configuring Basic Network Information (CLI)
This section provides information about the commands you use to configure
basic network information on the PowerConnect
M6220/M6348/M8024/M8024-k switch. For more information about these
commands, see the
Reference Guide
Enabling the DHCP Client on the OOB Port
Beginning in Privileged EXEC mode, use the following commands to enable
the DHCP client on the OOB port.
Command
configure
interface out-of-band
ip address dhcp
CTRL + Z
show ip interface out-of-
band
Enabling the DHCP Client on the Default VLAN
Beginning in Privileged EXEC mode, use the following commands to enable
the DHCP client on the default VLAN, which is VLAN 1.
Command
configure
interface vlan 1
ip address dhcp
ipv6 address dhcp
CTRL + Z
show ip interface vlan 1 Display network information for VLAN 1.
136
Setting Basic Network Information
PowerConnect M6220/M6348/M8024/M8024-k CLI
at support.dell.com/manuals.
Purpose
Enter Global Configuration mode.
Enter Interface Configuration mode for the OOB port.
Enable the DHCP client.
Exit to Privileged EXEC mode.
Display network information for the OOB port.
Purpose
Enter Global Configuration mode.
Enter Interface Configuration mode for VLAN 1.
Enable the DHCP client.
Enable the DHCPv6 client.
Exit to Privileged EXEC mode.
- Quick Links:
- Simple Mode
Hide quick links:
Advertisement
Table of Contents
