Toshiba e-STUDIO206L Service Manual page 1005

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO206L:

Table of Contents

After the update is completed properly, the LED on the download jig blinks (at an interval of

approx. 1 sec.).

The LED starts blinking approx. 50 sec. after the update starts. It is assumed that the update has

failed if it does not start blinking even though 2 min. has passed. In this case, shut down the

equipment and check the following items. Then clear the problems and restart updating from the

Is the download jig connected properly?

Is the ROM installed to the download jig properly?

Is the updating data written on the ROM of the download jig properly?

Do the download jig, RADF and the equipment operate properly?

Press the [ON/OFF] button on the control panel to shut down the equipment and turn the power

OFF using the main power switch.

Remove the download jig and install the RADF rear cover.

Close the front cover.

[B] Confirmation of the updated data

After the updating is completed, check each data version in Setting Mode (08) to confirm that the data

were overwritten properly.

 P. 11-81 "11.7 Confirmation of the updated data"

e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507

FIRMWARE UPDATING

Show Quick Links

Table of Contents

Troubleshooting