When Firmware Updating Fails - Toshiba e-STUDIO206L Service Manual

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO206L:

Table of Contents

11.8 When Firmware Updating Fails

When the equipment was shut down during firmware updating or it could not be started after updating

for some reason, perform firmware updating again following the procedure below.

Update "System ROM" of the system control PC board (SYS board) using the download jig.

Updating with the USB media becomes possible only after the "System ROM" (OS data) has

been updated.

See the updating procedure below for details.

 P. 11-34 "11.4 Firmware Updating with PWA-DWNLD-350-JIG1"

Update "Master Data", "Engine ROM", "Scanner ROM" and "RADF ROM" using the USB media.

See the updating procedure below for details.

 P. 11-11 "11.2 Firmware Updating with USB Media"

When the update with the USB media for "Engine ROM", "Scanner ROM" and "RADF ROM"

failed, update these ROMs using the respective download jigs in the table below.

If the equipment cannot be started even when the above update has been performed, check that

there is no damage to the "SYS board", "LGC board", "SLG board" or "DLG board". Replace

them if necessary.

e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507

FIRMWARE UPDATING

Storage location

Logic PC board

Scanning section control

Download jig

PWA-DWNLD-350-JIG1

 P. 11-42 "11.4.3 Engine

K-PWA-DLM-320

 P. 11-46 "11.5.1 Scanner

ROM (e-STUDIO206L/256/

306/356/456/506 only)"

K-PWA-DLM-320

 P. 11-48 "11.5.2 RADF

firmware (MR-3021/3022)"

Show Quick Links

Table of Contents