Overlay (Cl,C2) - HP 1652B Getting Started Manual

Hide thumbs Also See for 1652B:

Table of Contents

Overlay (Cl,C2)

t a we have been displaying so far in this section are examples using

just single channels. These examples display a single input channel in

each waveform display.

Suppose you wanted to take the signal from CH 1 and compare it to the

signal from CH 2. The easiest way to do this would be to put both

waveforms on the same waveform display, or overlay the waveforms.

1. Select CH 1,then select Modify waveform. Select Cl,C2, then

touch the RUN key. CH 2 is now overlayed on CH 1 in the top

waveform display.

2. Select the s/Div field and change the sweep speed to 5 ns/div.

This will allow us to see the overlayed waveforms easier. The

display should now look like the figure below.

To get a better display of the two waveforms overlayed, use an extra

ong cable on one of the inputs. This will delay one waveform.

Front-Panel Reference

IRepetltlve]

Overlay Waveform Display

Channel Menu

Chapters

Table of Contents